Kenwood CS-1022 Instruction Manual

Also see for CS-1010: Instruction manual

CS-1022, 1021, 1012®O00®©88v¥HG®© ©@@w&Fig. 4CS-1022, 1021, 1012 CS-1020, 1010@2 MODEFive-position push switch; selects the basic operatingmodes of the oscilloscope.CH1: Only the input signal to channel 1 isdisplayed as a single trace.CH2: Only the input signal to channel 2 isdisplayed as a single trace.ADD: When both CH1 and CH2 buttons are{(CH1 +CH2) engaged, the waveforms from channel 1and channel 2 inputs are added and thesum is displayed as a single trace. Whenthe CH2 INV ( button is engaged, thewaveform from channel 2 is subtractedfrom the channel 1 waveform and the dif-ference is displayed as a single trace.ALT: Alternate sweep is selected regardless ofsweep time.CHOP: Chop sweep is selected regardless ofsweep time at approximately 250 kHz.(3 POWER, SCALE ILLUMFully counterclockwise rotation of this control (OFFposition) turns off oscilloscope. Clockwise rotationturns on oscilloscope. Further clockwise rotation ofthe control increases the illumination level of scale.POWER, SCALE ILLUM (Except CS-1021)Fully counterclockwise rotation of this control (OFFposition) turns off oscilloscope. Clockwise rotationturns on oscilloscope. Further clockwise rotation ofthe control increases the illumination level of the scale.PILOT LampLamp Lights when oscilloscope is turned on.PILOT LampLights when oscilloscope is turned on.10