Kenwood CT/KXF-W Instruction Manual

Also see for CT-203: Instruction manual Instruction manual Instruction manual Instruction manual Service manual

Kenwood CT/KXF-W Instruction Manual Manual pdf 25 page image

25CT-2050/203/KXF-W6010/W4010 (En/M)In case of difficultySymptomSounds is not produced when the Play key ispressed.The deck does not work when an operationkey is pressed.DPSS malfunctions.CCRS does not work.The dubbing on Deck A and Deck B ends atdifferent timing.The cassette holder does not open when theeject(0)key is pressed.Sound is hoarse, or high frequencies are notaudible.Sound is distorted.RemedyCause÷ Please note that resetting microcomputer clears contentsstored inand returns it to the condition when it left the factory.What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the tablebelow to see if the problem can be corrected before seeking help from your dealer or service representative.÷ Connect the cords properly referring to "Sys-tem connections". 6÷Clean the head referring to "Cleaning thehead section". 4÷ Replace the tape.÷ Play a recorded tape.÷ Close the cassette holder completely.÷ Press the desired operation key in a fewseconds after closing the cassette holder.÷ Press the desired operation key in more than3 seconds after turning the power on.÷ Insert a tape.÷ Replace the tape.÷ Change the tape transport direction or insertthe tape inversely.÷ Read “Convenient music search (DPSS)”.$÷ Insert a recordable tape in deck B and pressthe CCRS key.÷ Place a disc in the CD player and press theCCRS key.÷ Connect the system control cord securely.÷ Clean the disc, place it in the CD player, andpress the CCRS key.÷ A small time difference is not regarded as afailure.÷ Press in the stop mode.÷ Clean the head referring to "Cleaning thehead section". 4÷ Replace the tape.÷ Adjust the recording level referring to "Howto record". ^÷ Replace the tape.÷ The connection cords are connected improp-erly.÷ The head is dirty.÷ Tape is irregularly wound and hard to take up.÷ A non-recorded tape is being played.÷ The cassette holder is not closed completely.÷ The operation key was pressed immediatelyafter closing the cassette holder.÷ An operation key is pressed in less than 3seconds after this unit is turned ON.÷ Tape is not inserted.÷ Tape is irregularly wound and hard to take up.÷ Tape has been fully wound to reel.÷ The tape is not suitable for DPSS operation, forexample the spaces between tunes are tooshort.÷ A recordable tape is not inserted in deck B.÷ A disc is not placed in the CD player.÷ The system control cord may be disconnected.÷ The disc is dirty.÷ This is due to the difference in tape length or tothe characteristics of the cassette deck mecha-nisms.÷ The key is pressed during recording or play-back.÷ The head is dirty.÷ The tape is stretched or wrinkled.÷ The recording level was too high.÷ A tape recorded with distorted sound is beingplayed.Operation to resetThe microcomputer may fall into malfunction (impossibility to oper-ate, erroneous display, etc.) when the power cord is unplugged whilethis unit is ON or due to an external factor. In this case, execute thefollowing method to reset the microcomputer and return it to normalcondition.Turn the power switch on and off again while pressing the stop(7)key on deck B.

/ 28

Related manuals for Kenwood CT-203