Kenwood D-R350 Instruction Manual

Kenwood D-R350 Instruction Manual Manual pdf 16 page image

D-R350 (En)16Programmed play (PGM mode)Use the following procedure to program desired tracks in adesired order. (Up to 32 tracks)÷ Load a disc in the CD player.÷ Set the INPUT SELECTOR to ”CD“ on theconnected device such as AV CONTROLCENTER or receiver.Press so that the “PGM” indicator lights.1PreparationGRC operationRC operation: Keys and control used in the operations described on this page.P.MODEDo this operation in the stop mode.2 GRC operationRC operationProgram desired tracks.In the case of a CD-TEXT disc, the track’s title is scrolled on the display.1 Select the disk.+1054321098762 Select the desired track No.Go to step 2 within 8 seconds.Press the numeric keys as shown below....To enter track No. 25: 005RC operationGo to step 3 within 8 seconds.3 Set the entry.4 Repeat steps 1, 2 and 3 above.3 GRC operationRC operation6PGMModeP.modeENTERENTERENTERDisc SkipENTER1 2 34 5 67 8 90 +10ENTERP.modeENTERENTERGP 0M 1 ID CS ?Blinks.GP 0M 1 1D T ON ?. ?GP 0M 1 1D T ON 2. 5«GP 0M 1 BA DC FE HGIn the case of a CD-TEXT disc, the disc title is scrolled on the display.REPEATDISC SKIPP.MODEPress the ENTER key after selecting each numeric icon. #GRC operation÷ Tracks can also be selected by pressing the 4 or ¢ key.÷ Up to 32 tracks can be programmed. When “FULL” is displayed, nomore tracks can be programmed.÷ If you make a mistake, press the CLEAR key and enter the track No.from the beginning.GP 0M 1 1D T ON 2. 5÷ When the 4 or ¢ key is pressed during playback, the track will beskipped in the direction of the pressed button.÷ When the 4 key is pressed once during playback, the play positionreturns to the beginning of the current track being played.To stop playbackPress the 7 key.÷ The programmed contents remain in memory.GRC operation : Complete the procedure in “Basic Operationsfor the Graphical Remote Control Unit (GRC)”90Start playback.