Kenwood D-R350 Instruction Manual

Kenwood D-R350 Instruction Manual Manual pdf 20 page image

D-R350 (En)20The following procedure allows to record a CD within the specified tape length so that no music is interrupted in the middleat the ends of sides A and B.Editing1 Light the “EDIT” indicator.Preparation ÷ Load a disc in the CD player.÷ Check that the unit is in the normal playTRACK mode. #÷ Set the INPUT SELECTOR to ”CD“ on theconnected device such as AV CONTROLCENTER or receiver.2 Set the entry.TimeENTER1 Select the time.When using the TIME key:+1054321098761 2 34 5 67 8 90 +10ENTERWhen using the numeric keys:GRC operationRC operation3GRC operationRC operationModeEditENTERENTER: Keys and control used in the operations described on this page.EDIT MODE DE TI D SI ?CBlinks.÷ Do this operation in the stop mode.RC operation Press the numeric keys as shown below...30-minute tape : 000)46-minute tape : 00006GRC operation Press the ENTER key after selecting each numericicon.30-minute tape : 0ENTER, 0ENTER,0ENTER, )ENTERDE TI D SI 3C C 4- 6÷ Recording within 99 minutes can be specified in minutes (2 digits).÷ If you commit a mistake in time entry, press the P.MODE key andrestart the procedure from the beginning.÷ By pressing the TIME key the set time-length intervals will change inthis order:÷ The interval length can be adjusted with the skip keys 4 and ¢ inunits of one minute (to a maximum of 99 minutes)."46=54=60=74=90=??"=ENTERE d i tGRC operation : Complete the procedure in “Basic Operationsfor the Graphical Remote Control Unit (GRC)”90Enter the recording time of the tape.Go to step 3 within 8 seconds.GRC operationRC operationDisc SkipENTERE d i tENTERSelect the disc.2Go to step 2 within 8 seconds.If more than 8 seconds have elapsed,press the key again.REPEATDISC SKIPEDIT MODEáEDIT MODETIME