Kenwood D-R350 Instruction Manual

Kenwood D-R350 Instruction Manual Manual pdf 2 page image

D-R350 (En)2Before applying power Caution : Read this section carefully to ensure safe operation.Units are designed for operation as follows.U.S.A. and Canada ................................................................ AC 120 V onlyAustralia .................................................................................. AC 240 V onlyEurope and U.K. ..................................................................... AC 230 V onlyChina ......................................................................................... AC 220 V only*Other countries ............................ AC 110-120 / 220-240 V switchableThe marking is located on the rear panel and says that the compo-nent uses laser beams that have been classified as Class 1. It meansthat the unit is utilizing laser beams that are of a weaker class. Thereis no danger of hazardous radiation outside the unit.CLASS 1LASER PRODUCTThe marking of products using lasers(Except for some areas)Introduction*AC voltage selectionThe AC voltage selector switch on the rear panel is set to the voltage thatprevails in the area to which the unit is shipped. Before connecting thepower cord to your AC outlet, make sure that the setting position of thisswitch matches your line voltage. If not, it must be set to your voltage inaccordance with the following direction.Move switch lever to match your line voltagewith a small screwdriver or other pointed tool.Note:Our warranty does not cover damage caused by excessive line volt-age due to improper setting of the AC voltage selector switch.For the United KingdomFactory fitted moulded mains plug1. The mains plug contains a fuse. For replacement, use only a 13-Amp ASTA-approved (BS1362) fuse.2. The fuse cover must be refitted when replacing the fuse in the moulded plug.3. Do not cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reacha power point, then obtain an appropriate safety approved extension lead or adapter, or consult your dealer.If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertentconnection to the mains supply.IMPORTANTThe wires in the mains lead are coloured in accordance with the following code:Blue : NeutralBrown : LiveDo not connect those leads to the earth terminal of a three-pin plug.WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THISAPPLIANCE TO RAIN OR MOISTURE.Safety precautionsTHE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERTTHE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURETHAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.Caution : Read this section carefully to ensure safe operation.THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THEPRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATUREACCOMPANYING THE APPLIANCE.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (ORBACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIEDSERVICE PERSONNEL.AC voltage selector switchLRLINE OUTPUT DIGITAL OUTPUTOPTICALAC 110-120VAC 220-240VCOAXIALSISTEMCONTROLTEXTAC 110-120VAC 220-240VREQUIREMENT BY NEDERLAND GAZETTEBatteries are supplied with this product. Whenthey empty, you should not throw away. Instead,hand them in as small chemical waste.