| 
English 55Tone Setup (DDX6054)You can set a Tone curve.Display the Equalizer screen1Touch [ ] > [ ] > [Equalizer]. (page 53)Display the Tone Control screen2Set the Tone3[Bass] Bass adjustment items are displayed.[Middle] Middle adjustment items aredisplayed.[Treble] Treble adjustment items are displayed.[Flat] Tone level becomes 0 (flat).[FREQ] Sets the Center frequency.[Level] Sets the level.[Q Factor] Sets the Q factor. (Only [Bass] and[Middle] can be set)[Bass DC EXT] Bass DC Extend settings. (Only[Bass] can be set)If turned "ON", it extends the bass centerfrequency to the low register by approximately20%.[SW Level] Adjusts the subwoofer volume.Zone ControlYou can set the front and rear audio source.Display the Zone Control screen1Touch [ ] > [ ] > [Zone Control]. (page 53)Set the Zone Control2[Single Zone] Turns off the dual zone.[Front Source] Sets the front audio source.[Rear Source] Sets the rear audio source.⁄When the rear speaker sound is switched, the audio•source that is output at the AV OUTPUT terminal isalso switched to the same source.[Rear VOL.] Adjusts the volume of the rearchannel.⁄There are following limitations when zone function is set•to "ON".- There is no output from the subwoofer.- (page 54), (page56), (page 56), (page73), (page 74), and Setup> (page 75) are not available. |
