Kenwood DDX6054 Instruction Manual

Also see for DDX6054: Service manual Installation manual

Contents

English 91Help? ErrorWhen the unit fails to operate correctly, thecause of the failure appears on the display."Protect" :Protective circuit has been activated because a speakercord has shorted or it has come in contact with the carchassis.➡ Wire or insulate the speaker cord as appropriateand then push the Reset button."Hot Error" :When the internal temperature of this unit rises to 60°Cor more, the protection circuit is activated and youmay not be able to operate the unit. At such times thismessage will appear.➡ Use the unit again after reducing thetemperature inside the vehicle."Hold Error" :Activation of the protective circuit when thetemperature inside the disc changer is higher than 60degrees Celsius stops the disc changer from operating.At such times this message will appear.➡ Use when the temperature at the site where thedisc changer has been fitted has dropped."Mecha Error" :The disc player is malfunctioning.➡ Eject the disc and try inserting it again. Contactthe Kenwood dealer if this indicator continuesblinking or the disc cannot be ejected."Disc Error" :An unplayable disc is inserted."Read Error" :Disc is quite dirty.➡ Clean the disc, referring tot he section on (page 6).Disc is upside down.➡ Load the disc with the labeled side up."Region code Error" :The disc you wanted to play has a region code thatcannot be played with this unit."Parental level Error" :The disc you wanted to play has a higher level than theparental level you set."Error 07–67" :The unit is not operating correctly due to some reasonor other.➡ Push the unit's Reset button. If the "Error 07−67"message does not disappear, see your nearestKenwood dealer."No Device" (USB device):The USB device is selected as a source although no USBdevice is connected.➡ Change the source to any source other thanUSB/iPod. Connect an USB device, and changethe source to USB again."Disconnected" (iPod, Bluetooth audio player):The iPod/Bluetooth audio player is selected as a sourcealthough no iPod/Bluetooth audio player is connected.➡ Change the source to any source other thaniPod/Bluetooth. Connect an iPod/Bluetoothaudio player, and change the source to iPod/Bluetooth again."No Music" :The connected USB device contains no playable audiofile.Media was played that doesn’t have data recorded thatthe unit can play."USB Device Error!!" :The connected USB device is rated a current capacityhigher than the allowable limit.➡ Check the USB device.Some trouble may have occurred to the connectedUSB device.➡ Change the source to any source other than USB.Remove the USB device."Authorization Error" :Connection to the iPod has failed.➡ Remove the iPod and then reconnect it.The unit does not support the iPod.➡ Refer to this unit> (page 8)."Update your iPod" :The iPod's software is an older version which the unitcan not support.➡ Confirm that the software for the iPod is thelatest version. Refer to connected to this unit> (page 8)."Update your USB database" :The USB device is different from the previous one orthe contained audio files are replaced.➡ Update your database. Refer to Screen> of USB Device Control (page 22).