Kenwood DDX8046BT Instruction Manual

Also see for DDX8046BT: Installation manual Instruction manual Instruction manual

Contents

DDX series DDX896/ DDX8046BT English 117Next page 3Help? ErrorWhen the unit fails to operate correctly,the cause of the failure appears on thedisplay."Protect" :Protective circuit has been activated becausea speaker cord has shorted or it has come incontact with the car chassis.➡ Wire or insulate the speaker cord asappropriate and then push the Resetbutton."Hot Error" :When the internal temperature of this unitrises to 60°C or more, the protection circuit isactivated and you may not be able to operatethe unit. At such times this message willappear.➡ Use the unit again after reducing thetemperature inside the vehicle."Mecha Error" :The disc player is malfunctioning.➡ Eject the disc and try inserting it again.Contact the Kenwood dealer if this indicatorcontinues blinking or the disc cannot beejected."Disc Error" :An unplayable disc is inserted."Read Error" :Disc is quite dirty.➡ Clean the disc, referring tot he section on (page 4).Disc is upside down.➡ Load the disc with the labeled side up."Region code Error" :The disc you wanted to play has a region codethat cannot be played with this unit."Parental level Error" :The disc you wanted to play has a higher levelthan the parental level you set."Error 07–67" :The unit is not operating correctly due tosome reason or other.➡ Push the unit's Reset button. If the "Error07−67" message does not disappear, seeyour nearest Kenwood dealer."No Device" (USB device):The USB device is selected as a sourcealthough no USB device is connected.➡ Change the source to any source otherthan USB/iPod. Connect an USB device, andchange the source to USB again."Disconnected" (iPod, Bluetooth audioplayer):The iPod/Bluetooth audio player is selectedas a source although no iPod/Bluetooth audioplayer is connected.➡ Change the source to any source other thaniPod/Bluetooth. Connect an iPod/Bluetoothaudio player, and change the source toiPod/Bluetooth again."No Music" :The connected USB device contains noplayable audio file.Media was played that doesn’t have datarecorded that the unit can play."USB Device Error!!" :The connected USB device is rated a currentcapacity higher than the allowable limit.➡ Check the USB device.Some trouble may have occurred to theconnected USB device.➡ Change the source to any source other thanUSB. Remove the USB device."Authorization Error" :Connection to the iPod has failed.➡ Remove the iPod and then reconnect it.The unit does not support the iPod.➡ Refer to connected to this unit> (page 7).