FCC WARNINGThis equipment may generate or use radiofrequency energy. Changes or modifications to thisequipment may cause harmful interference unlessthe modifications are expressly approved in theinstruction manual. The user could lose the authority tooperate this equipment if an unauthorized change ormodification is made.NOTEThis equipment has been tested and found tocomply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection againstharmful interference in a residential installation.This equipment may cause harmful interference toradio communications, if it is not installed and usedin accordance with the instructions. However, thereis no guarantee that interference will not occur in aparticular installation. If this equipment does causeharmful interference to radio or television reception,which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct theinterference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment andreceiver.• Connect the equipment into an outlet on a circuitdifferent from that to which the receiver is connected.• Consult the dealer or an experienced radio/TVtechnician for help.DNX9960/ DNX7160/ DNX7020EX/ DDX896:IC (Industry Canada) NoticeOperation is subject to the following twoconditions:(1) This device may not cause interference, and(2) this device must accept any interference,including interference that may causeundesired operation of the device.The term "IC: " before the certification/registration number only signifies that theIndustry Canada technical specification weremet.This product contains a CR Coin Cell LithiumBattery which contains Perchlorate Material– special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorateDDX8046BT:The marking of products using lasersCLASS 1LASER PRODUCTThe label is attached to the chassis/case andsays that the component uses laser beams thathave been classified as Class 1. It means that theunit is utilizing laser beams that are of a weakerclass. There is no danger of hazardous radiationoutside the unit.DNX9960/ DNX7160/ DNX7020EX/ DDX896:2CAUTIONUse of controls or adjustments or performance ofprocedures other than those specified herein mayresult in hazardous radiation exposure.In compliance with Federal Regulations, followingare reproductions of labels on, or inside the productrelating to laser product safety.Kenwood Corporation2967-3, ISHIKAWA-MACHI,HACHIOJI-SHITOKYO, JAPANKENWOOD CORP. CERTIFIES THIS EQUIPMENTCONFORMS TO DHHS REGULATIONS N0.21 CFR1040. 10, CHAPTER 1, SUBCHAPTER J.Location : Bottom Panel