DDX series DDX896/ DDX8046BT English 93Next page 3Next page 3Navigation SetupNavigation SetupYou can set Navigation parameters.1 Display the Navigation Setup screenTouch [ ] >> [ ] >> [Navigation].(page 78)2 Set each item[NAV Interrupt Speaker] Selectsspeakers used for voice guidance of thenavigation system. ( "Front All")"Front L": Uses the front left sidespeaker for voice guidance."Front R": Uses the front right sidespeaker for voice guidance."Front All": Uses both front speakers forvoice guidance.[NAV Voice Volume] Adjusts thevolume for voice guidance of thenavigation system.( DNX series: "25", DDX series: "21")[NAV Mute] Mutes the volume of rearspeakers during voice guidance of thenavigation system. ( "ON")When turned "ON", the volume leveldrops for voice guidance.[Navigation Input] Selects a navigationsystem connection. ( "RGB") (DDXseries only)"RGB": Allows the Kenwood’sNavigation System to connect via itsinterface cable."AV-IN": Allows a third-party navigationsystem to connect via the AV INPUT1port."OFF": Must be used if no navigationsystem is connected. (The navigationdisplay is cancelled when the AVsource is switched.)[On Screen Navigation] Sets anon-screen display of the navigationscreen. ( "OFF") (DDX series only)"Auto": Information is displayed for 5seconds when updated. (Example :when the track/file/song has changedto the next one.)"OFF": Information is not displayed.⁄• [On Screen Navigation]It can be set only when [Navigation Input] is setto "AVIN".DSP Bypass Control (DNX7 series)DSP Bypass Control (DNX7 series)Temporarily bypassing DSP (Digital SignalProcessor) System.1 Display the Audio SETUP screenTouch [ ] >> [ ] >> [Audio SETUP].(page 78)2 Set the DSP Select[Bypass] There is no effect by DSP.[Through] There is an effect by DSP.⁄• When the mode is set to [Bypass], DSP Systemcannot be adjusted.