Kenwood DPX-7010MD Instruction Manual

Also see for DPX-7010MD: Service manual Service manual

Kenwood DPX-7010MD Instruction Manual Manual pdf 11 page image

— 11 —Store the frequency of a station. You can then recall thatstation with a single touch of a button.Select the band/ station that you want to have stored.Press the button (#1-6) that you want to use for the station, forat least two seconds.The button number blinks once in the display to indicate thatthe data has been stored.Recalling a Preset Station:Press the preset station button (#1-6) for the desired station.The number of the recalled station is displayed.You can store six stations in each of the FM1, FM2, FM3, andAM bands.NOTE21Station Preset MemoryPress the SRC (source) button repeatedly to select the tunermode. "TUNER" is displayed when the tuner mode has beenselected.Press either the FM or AM button to select the band.Each time you press the FM button, the band switchesbetween the FM1, FM2 and FM3.Press the AM button to select the AM bands.• Auto Seek TuningPress the ¢ button to seek higher frequencies.Press the 4 button to seek lower frequencies.• Manual TuningPress the ¢ button to increase the frequency by one step.Press the 4 button to decrease the frequency by one step.• Please see the function settings about selecting tuning mode.(page 25)• The ST indicator lights up when stereo broadcasts are beingreceived.NOTE321TuningSwitch the frequency step used in seeks. The factory defaultsare 50 kHz for FM and 9 kHz for AM.Turn the power off.Hold down buttons #1 and #5, then turn the power back on.The frequency step settings will be changed to 200 kHz for FMand 10 kHz for AM.When you change the frequency step settings, all memorycontents will be erased.Returning Frequency Step Settings to Original Values:Repeat steps 1 and 2 above.NOTE21Frequency Step Setting