Kenwood DPX-7010MD Instruction Manual

Also see for DPX-7010MD: Service manual Service manual

Kenwood DPX-7010MD Instruction Manual Manual pdf 29 page image

— 29 —10–+–+–+–+–+ANTCONTCONTP.CONTILLUMIFRONT•LFRONT•RREAR•LREAR•REXT.CONTCONTConnecting Wires to TerminalsWhen only two speakers are being connected to the system, connectthe connectors either to both the front output terminals or to both therear output terminals (do not mix front and rear). For example, if youconnect the + connector of the left speaker to a front outputterminal, do not connect the - connector to a rear output terminal.2CAUTIONKENWOOD disc changer control inputTo connect the Disc changer,consult your Disc changer manual.NOTEIf you connect the ignition wire (red) and the battery wire(yellow) to the car chassis (ground), you may cause a shortcircuit, that in turn may start a fire. Always connect thosewires to the power source running through the fuse box.2WARNINGFM/AM antenna inputFuse(10A)Wiring harness(Accessory#)White/BlackGray/BlackGreen/BlackPurple/BlackWhiteGrayGreenPurpleTo front leftspeakerTo front rightspeakerTo rear rightspeakerTo rear leftspeakerIgnition wire (Red)Battery wire (Yellow)Ground wire (Black) - (To car chassis)Ignition keyswitchCar fusebox(Mainfuse)ACCCar fuse boxBatteryWhen using the optional power amplifier,connect to its power control terminal.To car light control switchDepending on what antenna you are using,connect either to the control terminal of themotor antenna, or to the power terminal for thebooster amplifier of the film-type antenna.External amplifier control wire(Pink / Black)Motor antenna control wire(Blue)Automatic illumination/Dimmercontrol wire (Orange)Rear left output (White)/Non-fading left output (White)Rear right output (Red)/Non-fading right output (Red)Power control wire(Blue/White)To "EXT.AMP.CONT." terminal of the amplifierhaving the external amp control function.Front left output (White)Front right output (Red)