Kenwood DPX502U Instruction Manual

Also see for DPX502U: Firmware update guide Service manual

Kenwood DPX502U Instruction Manual Manual pdf 10 page image

10 | EnglishGeneral featuresSubwoofer OutputTurning the Subwoofer output ON or OFF.Push the Control knob toward down for at least2 seconds.Each time you push the knob, Subwoofer outputswitches ON and OFF.When it is ON, "SW ON" is displayed.Audio SetupSetting the Sound system, such as Cross overNetwork.1 Select the source to adjustPress the [SRC] button.2 Enter Audio Setup modePress the [VOL] knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Setup the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeFront High Pass Filter "HPF" Through/40/60/80/100/120/150/180/220 HzRear High Pass Filter "HPR" Through/40/60/80/100/120/150/180/220 HzLow Pass Filter "LPF" 50/60/80/100/120/Through HzSubwoofer Phase "PHAS" Reverse (180°)/ Normal (0°)Volume offset "V-OFF" –8 — ±0 (AUX: -8— +8)Loudness "LOUD" OFF/ONDual Zone System "2ZON" OFF/ON⁄• Volume offset: Sets each source’s volume as a differencefrom the basic volume.• Loudness: Compensates for low and high tonesduring low volume. (Only the low tone iscompensated for when the tuner is selectedas a source.)• Dual Zone SystemMain source and sub source (Auxiliary input) outputFront channel and Rear channel separately.- Set up the channel of sub source by System Setting> (page 27).- Select Main source by [SRC] button.- Adjust the volume of Front channel by [VOL] knob.- Adjust the volume of Rear channel by

(page 8).- The Audio Control has no effect on sub source.• You can use the Dual Zone System with the internalauxiliary input.5 Exit Audio Setup modePress the [VOL] knob for at least 1 second.Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1 Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2 Enter Speaker Setting modePress the [VOL] knob.3 Select the Speaker typeTurn the [VOL] knob.Each time you turn the knob, the setting alternatesbetween the settings shown in the table below.Speaker type DisplayOFF "SP OFF"For 5 & 4 in. speaker "SP 5/4"For 6 & 6x9 in. speaker "SP 6*9/6"For the OEM speaker "SP OEM"4 Exit Speaker Setting modePress the [VOL] knob.