Kenwood DPX502U Instruction Manual

Also see for DPX502U: Firmware update guide Service manual

Kenwood DPX502U Instruction Manual Manual pdf 8 page image

8 | EnglishGeneral featuresAttenuatorTurning the volume down quickly.Press the [ATT] button.Each time you press the button, the Attenuatorturns ON and OFF.When the Attenuator is ON, the "ATT" indicatorblinks.VolumeIncreasing VolumeTurn the [VOL] knob clockwise.Decreasing VolumeTurn the [VOL] knob counterclockwise.System QSelecting the best sound setting preset for differenttypes of music.1 Select the source to setPress the [SRC] button.2 Select the Sound typePress the [Q] button.When you press the button once, the currentsound setting is displayed.Each time you press the button, the sound settingalternates.Sound setting DisplayUser memory "USER"Rock "ROCK"Pops "POPS"Easy "EASY"Top 40 "TOP40"Jazz "JAZZ"Natural "NATURAL"⁄• User memory: The values set on the

(page 8).• Change each setting value with the (page 10).First, select the speaker type with the Speaker setting.Audio Control1 Select the source to adjustPress the [SRC] button.2 Enter Audio Control modePress the [VOL] knob.3 Select the Basic Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Basic Audio itemTurn the [VOL] knob.Adjustment Item Display RangeRear Volume "R-VOL" 0 — 35Subwoofer level "SW L" –15 — +15Bass level* "BAS L" –8 — +8Middle level* "MID L" –8 — +8Treble level* "TRE L" –8 — +8Balance "BAL" Left 15 — Right 15Fader "FAD" Rear 15 — Front 15Exit Audio Control mode (Volume control mode)* You can adjust these items in detail. Refer to the detail of Audio Control> (Page9).* Source tone memory: Puts the set up value in thememory per source. (Detail Audio item is included)5 Exit Audio Control modePress any button.Press a button other than the [VOL] knob and [ATT]button.