Kenwood KDC-4027 Instruction Manual

— 28 —English The messages shown below display your systemscondition.EJECT: No disc magazine has been loaded in the changer.The disc magazine is not completely loaded.E01➪ Load the disc magazine properly.No CD in the unit.➪ Insert the CD.NO DISC: No disc has been loaded in the disc magazine.E02➪ Load a disc into the disc magazine.E-04: No disc has been loaded in the disc magazine.E04➪ Load a disc into the disc magazine.The CD is quite dirty. The CD is upside-down. The CDis scratched a lot.➪ Clean the CD and load it correctly.BLANK: Nothing has been recorded on the MD.E10NO TRACK: No tracks are recorded on the MD, although it has atitle.E11NO PANEL: The faceplate of the slave unit being connected tothis unit has been removed.E30➪ Replace it.E-77: The unit is malfunctioning for some reason.E77➪ Press the reset button on the unit. If the "E-77"code does not disappear, consult your nearestservice center.E-99: Something is wrong with the disc magazine. Or theunit is malfunctioning for some reason.E99➪ Check the disc magazine. And then press the resetbutton on the unit. If the "E-99" code does notdisappear, consult your nearest service center.HOLD: The protective circuit in the unit activates when thetemperature inside the automatic disc changerexceeds 60°C (140°F), stopping all operation.E0d➪ Cool down the unit by opening the windows orturning on the air conditioner. As the temperaturefalls below 60°C (140°F), the disc will start playingagain.NO NAME: Attempted to display DNPS during the CD play havingno disc names preset.E51NO TITLE: Attempted to display the disc title or track title whilethe MD having no MD title is being played.E53NO TEXT: Attempted to display the disc text or track text whilethe CD having no CD text is being played.E54LOAD: Discs are being exchanged in the Disc changer.E57NO ACCES: After setting it in the Disc Changer, DNPP was donewithout having it been played at least 1 time.E58(Function of remote)IN (Blink): The CD player section is not operating properly.E59➪ Reinsert the CD. If the CD cannot be ejected or thedisplay continues to flash even when the CD hasbeen properly reinserted, please switch off thepower and consult your nearest service center.Troubleshooting Guide