Kenwood KDC-7080R/RV Instruction Manual

This function allows you to adjust the setting that is recalledwith the sound coordinate system, according to types ofspeakers.Press the SRC button repeatedly to select the standby mode."ALL OFF" is displayed when the standby mode is selected.Press the AUD button to enter the mobile preset plan mode.Press either the 4 or ¢ button to select the type ofspeaker. The setting switches as follows.Off / For the OEM speaker / For 6/6x9 in. speaker /For 5/4 in. speakerPress the AUD button to end the mobile preset plan mode.• This mode is available only when the Sound coordinate systemis on. (page31)NOTE4321Mobile PresetRecalling your sound settings:Press a preset button (#1-6) except during the bass centerfrequency, bass level, bass quality factor, bass extension,treble center frequency, and treble level adjust mode.This mode is available only when Sound coordinate system is on.NOTEquality factor, bass extension, treble center frequency, andtreble level adjust mode.• This setting can be made only when the Sound coordinatesystem is on. (page31)• The settings you can preset are, bass centre frequency, basslevel, bass quality factor, bass extension, treble centrefrequency, and treble level.NOTEStoring your sound settings:Hold down a preset button (#1-6) for two seconds or moreexcept during the bass center frequency, bass level, bass"V OFFSET" : Set the sound level of the each source selected byadjusting the level difference between the basicsound level and the required level.Setting values: - 8 – ± 0"Fader" : Adjust the fader level.Setting values: Front 15 – Rear 15"Balance" : Adjust the balance level.Setting values: Left 15 – Right 15"Treble" : Adjust the treble level.Setting values: - 8 – + 8"TreF" : Adjust the centre frequency of the treble.Setting values: 10.0 / 12.5 / 15.0 / 17.5 kHzThis mode is available only when the Sound coordinate system ison. ( page31).NOTEGeneral features— 10 —English