Kenwood KDC-7080R/RV Instruction Manual

• When removing the faceplate, pull it out only when it is fullyopen. The detachment of the faceplate whilst it is moving mightresult in damage to the unit.• Do not apply excessive force to the faceplate bracket withoutattaching the faceplate. Doing so will cause the faceplatebracket to be deformed.• Do not touch the connector on the faceplate bracket afterremoving the faceplate. Touching the connector may causedamage to the unit.• Do not touch two metal parts on both sides of the faceplatebracket. Touching those parts may injure you.• Sliding the faceplate lock switch cause the unit’s power to turnoff. If you want to operate the unit again, remove the faceplatefrom the faceplate bracket completely and then reattach it.• The faceplate is a precision piece of equipment and can bedamaged by shocks or jolts. For that reason, keep the faceplatein its special storage case whilst detached.• Do not expose the faceplate or its storage case to directsunlight or excessive heat or humidity. Also avoid places withtoo much dust or the possibility of water splashing.Reattaching the Faceplate:Hold the faceplate so that the control panel faces the fronttoward you and set the left side of the faceplate in thefaceplate bracket.Do not set the right side of the faceplate in the faceplate bracketfirst, when reattaching the faceplate. Doing so may cause theconnector on the faceplate bracket to malfunction.Press the right side of the faceplate until it locks.If the faceplate bracket's angle was not set to the vertical whenNOTE22CAUTION1NOTEThe faceplate can be detached from the unit, helping to detertheft.Removing the faceplate:Choose the way from among the following and open thefaceplate.Turn the ignition off, hold down the SRC button for one secondor more, or press the left part at the upper side of thefaceplate (as illustrated on p.13) for as many times as you havepreset in the "Manual Open Button Setting" (OPEN SW #) inthe menu when the control panel has been hidden.Set the faceplate's angle adjustment switch to "0" to set thefaceplate angle to the vertical.For details, refer to "Faceplate Angle Adjustment" (page 11).If the faceplate's angle adjustment switch is not set to "0" whenmounting the faceplate on the faceplate bracket, it may bedifficult to mount the faceplate or the faceplate may not besecurely attached and could fall off.Set the angle adjustment switch to "0" before removing thefaceplate.Slide the faceplate lock switch to the left during the periodwhich you have set in the "Time setting for removing thefaceplate" in the menu.Holding the centre part of the faceplate, pull it out.The faceplate bracket will automatically close.2CAUTION4Faceplate lock switch3NOTE21Removing the FaceplateGeneral features— 12 —English