Kenwood KDC-715S Instruction Manual

The operation and characters that can be entered may changeas listed below, depending on the unit that is connected.A press of the 38 button exits the disc name preset mode.Operations can be followed again from Step 2 at a time suchas this, and the characters to be input are selected using theprocedure described below.Press the DISC + or DISC– button to display the desiredcharacter. Besides the alphabet (capital letters only) andnumbers, you can choose the following characters: /, + , –, ∗,=, <, >, [ and ].Direct Alphabet Input(Function of remote with number/letter entry buttons)If the disc changers that were manufactured and sold after 1997(except for KDC-C560) are connected, you can directly inputletters using the number/letter entry buttons on the remote.Example: Use the following table to enter the name "DANCE".Continue steps 3 and 4 until all the characters are chosen forthe name.Press either the NAME.S button on the main unit or the OKbutton on the remote.The disc name is stored and the disc name preset mode iscanceled.If you make no entry in a 10-second period, the name will bestored with the characters input so far.• The number of characters and discs whose names can bestored will differ depending on the disc changer that isNOTE65Button to press # Times pressedCharacter#3 11#2#6 2#2 3#3 2“D”“A”“N”“C”“E”NOTENOTEStore the names of discs to be displayed when played.Play the disc whose name you want to preset.• This function is not available for disc changers that do notfeature the Disc Name Preset function.• This procedure is not to be used to store the disc and tracktitles for MDs that you record.• The disc name preset function cannot be used when a disc titlename or track title is displayed.Press the NAME.S button for at least two seconds."NAME SET" is displayed and the disc name preset mode isentered.The cursor blinks in the position where character input can bemade.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.You can also move the cursor left or right by pressing theTRACK+ or TRACK– buttons, respectively, on the remotecontrol.Each time the 38 button is pressed, the characters to beentered change as listed below.Press the DISC + or DISC– button to display the desiredcharacter.Characters that can be displayed are as follows.Alphabet (upper case): A ~ ZAlphabet (lower case): a ~ zNumerals and symbols: 0~9 @ ” ‘ ` % & ∗ + - = , . / \ < > [ ]Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä êë î ï ô ö û ü ñ ç © Æ › fi432NOTE1Presetting Disc Names (DNPS)CD/External disc control features— 28 —English