Kenwood KDC-8023 Instruction Manual

Also see for KDC-8023: Service manual Service manual

Switching the display mode.1 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "DISP" is displayed above the[3] button.Refer to (page 6).Display Mode SwitchingFine-tuning so that the System Q value is optimal when settingthe speaker type.1 Enter StandbyPress the [SRC] button.Select the "ALL OFF" display.2 Enter Speaker Setting modePress the [Q] button.3 Select the Speaker typePress the [2] — [5] button.Each time the button is pressed the setting switches as shownbelow.Speaker type Button DisplayOFF [2] "SP OFF"For 5 & 4 in. speaker [3] "SP 5/4inch"For 6 & 6x9 in. speaker [4] "SP 6*9/6inch"For the OEM speaker [5] "SP O.E.M."4 Exit Speaker Setting modePress the [Q] button.Speaker Setting3rd section[2] buttonAdjustment Item Display RangeVolume offset "V-Offset" –8 — ±0Volume offset: Each source's volume can be set as a differencefrom the basic volume.2nd section[2] buttonAdjustment Item Display RangeFront/RearHigh Pass Filter"HPF" Through/100/125/170 Hz[3] buttonAdjustment Item Display RangeNon-Fading "LPF NF" 50/80/120/Through HzLow Pass Filter[4] buttonAdjustment Item Display RangeLoudness "LOUD" ON/OFF[5] buttonAdjustment Item Display RangeNon-Fading level "NF Level" –15 — +15• Loudness: Compensating for low and high tones during lowvolume.• When the Dual Zone System is ON, the setting for the High PassFilter is nullified.General features— 10 —English