Kenwood KDC-8023 Instruction Manual

Also see for KDC-8023: Service manual Service manual

— 41 —Hold Error: The protective circuit in the unit activates when thetemperature inside the automatic disc changer exceeds 60°C(140°F), stopping all operation.E0d➪ Cool down the unit by opening the windows or turning onthe air conditioner. As the temperature falls below 60°C(140°F), the disc will start playing again.NO NAME: Attempted to display DNPS during the CD play having no discnames preset.E51Load: Discs are being exchanged in the Disc changer.E57-1Reading: The unit is reading the data on the disc.E57-2NO ACCESS: After setting it in the Disc Changer, DNPP was done withouthaving it been played at least 1 time.E58IN (Blink): The CD player section is not operating properly.E59➪ Reinsert the CD. If the CD cannot be ejected or the displaycontinues to flash even when the CD has been properlyreinserted, please switch off the power and consult yournearest service center.The messages shown below display your systemscondition.EJECT: No disc magazine has been loaded in the changer. The discmagazine is not completely loaded.E01➪ Load the disc magazine properly.No CD in the unit.➪ Insert the CD.No Disc: No disc has been loaded in the disc magazine.E02➪ Load a disc into the disc magazine.TOC Error: No disc has been loaded in the disc magazine.E04➪ Load a disc into the disc magazine.The CD is quite dirty. The CD is upside-down. The CD isscratched a lot.➪ Clean the CD and load it correctly.E-05: The CD is upside-down.E05➪ Load the CD correctly.Blank Disc: Nothing has been recorded on the MD.E10No Track: No tracks are recorded on the MD, although it has a title.E11E-15: Media was played that doesn’t have data recorded that theunit can play. E15➪ Use media that has data recorded that the unit can play.No Panel: The faceplate of the slave unit being connected to this unithas been removed.E30➪ Replace it.E-77: The unit is malfunctioning for some reason.E77➪ Press the reset button on the unit. If the "E-77" code doesnot disappear, consult your nearest service center.Mecha Error: Something is wrong with the disc magazine. Or the unit ismalfunctioning for some reason.E99➪ Check the disc magazine. And then press the reset buttonon the unit. If the "Mecha Error" code does not disappear,consult your nearest service center.

/ 42

Related manuals for Kenwood KDC-8023