Kenwood KDC-8026 Instruction Manual

Also see for KDC-8026: Service manual

Kenwood KDC-8026 Instruction Manual Manual pdf 33 page image

English | 33Installation• Make sure that the unit is installed securely in place. Ifthe unit is unstable, it may malfunction (for example, thesound may skip).• To attach this unit, make sure the front of the controlpanel faces you and fit it into the mounting sleeve bypressing the four corners of the hard rubber frame at thesame time.Do not apply strong pressure to other sections than thecorners; otherwise troubles such as the impossibility ofopening or closing the panel may result.• The hollow at the center of the rubber frame is designedto make it easier to remove discs.If you do not want the hollow to be visible, mount therubber frame in the opposite direction (with the flat sideat the top instead of the bottom).non-Japanese cars Japanese cars1 Refer to the section 'Removing the hard rubberframe' (page 35) and then remove the hardrubber frame.2 Align the holes in the unit (two locations on eachside) with the vehicle mounting bracket andsecure the unit with the accessory screws.• During installation, do not use any screws except forthose provided. The use of different screws might resultin damage to the main unit.• Damage may occur if a screwdriver or similar tool is usedwith excessive force during the installations.8 mmMAX.ø5mm ø5mm8mmMAX.TN TNT/NT: Toyota carsN: Nissan carsAccessory3...for Nissan carAccessory4 ...for Toyota car3 4Firewall or metal supportScrew (M4X8)(commercially available)Phillips truss head sheet metal screw(commercially available)Metal mounting strap(commercially available)Bend the tabs of themounting sleeve with ascrewdriver or similar utensiland attach it in place.