Kenwood KDC-BT41U Instruction Manual

Also see for KDC-4751SD: Service manual

Contents

Kenwood KDC-BT41U Instruction Manual Manual pdf 33 page image

English 33Continued to next pageTroubleshootingSymptom Remedy/CauseSound cannot be heard. Adjust the volume to the optimum level. / Check the cords and connections.“PROTECT” appears and no operationscan be done.Check to be sure the terminals of the speaker leads are covered with insulating tape properly,then reset the unit. If “PROTECT” does not disappear, consult your nearest service center.The unit does not work at all. Reset the unit.Radio reception is poor. / Static noisewhile listening to the radio.Connect the antenna firmly. / Pull the antenna out all the way.“IN” flashes. The CD player is not operating properly. Reinsert the disc properly. If the condition did notimprove, turn off the unit and consult your nearest service center.CD-R/CD-RW cannot be played backand tracks cannot be skipped.Insert a finalized CD-R/CD-RW (finalize with the component which you used for recording).Disc sound is sometimes interrupted. Stop playback while driving on rough roads. / Change the disc. / Check the cords andconnections.“NA FILE” appears. The unit is playing an unsupported audio file.“NO DISC” appears. Insert a playable disc into the loading slot.“TOC ERROR” appears. The CD is quite dirty. / The CD is upside-down. / The CD is scratched a lot. Try another discinstead.“ERROR 99” appears. The unit is malfunctioning for some reason. Press the reset button on the unit. If the “ERROR99” code does not disappear, consult your nearest service center.“COPY PRO” appears. A copy-protected file is played.“READ ERROR” appears. Copy the files and folders for the USB device again. If the error message is still displayed,initialize the USB device or use other USB devices.“NO DEVICE” appears. ■ No USB device is connected. Connect a USB device, and change the source to USB again.■ SD card is not inserted properly. Insert an SD card, and change the source to SD again.“NO MUSIC” or “ERROR 15” appears. The connected USB device or inserted SD card contains no playable audio file. / Media wasplayed that does not have data recorded that the unit can play.“NA DEVICE” appears. ■ Connect a supported USB device, and check the connections.■ Check that the supported SD card is inserted.“USB ERROR” appears. Remove the USB device, turn the unit off, then turn it on again. If the unit still showing thesame display, try to connect another USB device.“iPod ERROR” appears. Reconnect the iPod. / Confirm that the software for the iPod is the latest version. / Resetthe iPod.Noise is generated. Skip to another track or change the disc.Tracks cannot play back as you haveintended them to play.Playback order is determined when files are recorded.“READING” keeps flashing. Longer readout time is required. Do not use too many hierarchies and folders.Elapsed playing time is not correct. This is caused by how the tracks are recorded.The number of songs containedin “SONGS” category of this unitis different from that contained in“SONGS” category of iPod.Podcast files are not counted in this unit as this unit does not support the playback ofpodcast files.