English|19Audio AdjustmentsAudio SetupYou can set Sound system , such as follows;Adjustment ItemDisplayRangeFront High Pass Filter “HPF-F”Through/40/ 60/80/100/120/150/180/220 HzRear High Pass Filter“HPF-R”Through/40/ 60/80/100/120/150/180/220 HzLow Pass Filter“LPF”50/60/80/100/120/ThroughHzSubwoofer Phase“SW PHASE”Reverse (180°)/ Normal (0°)Volume offset“VOL-OFFSET”–8 — ±0 (AUX: -8— +8)Loudness“LOUD”OFF/ONDual Zone System“2 ZONE”OFF/ON⁄• Volume offset: Sets each source’s volume as a differencefrom the basic volume.• Loudness: Compensates for low and high tones duringlow volume. (Only the low tone is compensated forwhen the tuner is selected as a source.)• Dual Zone SystemMain source and sub source (Auxiliary input) outputFront channel and Rear channel separately.- Set up the channel of sub source by “Zone2” of (page 6).- Select Main source by [SRC] button.- Adjust the volume of Front channel by [AUD] knob.- Adjust the volume of Rear channel by (page 19) or [5]/[∞] button on the remote control(page 28).- The Audio Control has no effect on sub source.1Select the source to adjustFor how to select source item, refer to Source Select button> of (page4).2Enter Audio Setup modePress the [AUD] knob for at least 1 second.3Select the Audio Setup item to adjustPress the [AUD] knob.4Adjust the Audio setup itemTurn the [AUD] knob.5Exit Audio Setup modePress the [AUD] knob for at least 1 second.Audio ControlYou can adjust following Audio Control items ;Adjustment ItemDisplayRangeRear volume“REAR VOLUME”0 — 35Subwoofer level“SUB-W LEVEL”–15 — +15System Q“USER”/“ROCK”/“POPS”/“EASY”/“TOP40”/“JAZZ”/“NATURAL”User setting/Rock/Pops/Easy/Top 40/Jazz/NaturalBass level*“BASS LEVEL”–8 — +8Middle level*“MIDDLE LEVEL”–8 — +8Treble level*“TREBLE LEVEL”–8 — +8Balance“BALANCE”Left 15 — Right 15Fader“FADER”Rear 15 — Front 15Exit Audio Control mode (Volume control mode)* Source tone memory: Puts the set up value in thememory per source.⁄• “USER”: The ranges selected lastly for Bass level, Middlelevel, and Treble level are recalled automatically.1Select the source to adjustFor how to select source item, refer to Source Select button> of (page4).2Enter Audio Control modePress the [AUD] knob.3Select the Audio item to adjustPress the [AUD] knob.4Adjust the Audio itemTurn the [AUD] knob.5Exit Audio Control modePress any button.Press a button other than the [AUD] knob or [0]and [ATT] button.