Kenwood KDC-MP102U Instruction Manual

Contents

101 To enter [AUD CTRL] menu (see table below): Press AUDIO.To enter [SETTINGS] menu (page 11): Press the volume knob to enter [FUNCTION]mode. Turn the volume knob to select [SETTINGS], then press to enter.2 Turn the volume knob to make a selection, then press to confirm.See table below for selection.Repeat this step until the desired item is selected/activated.Press to return to the previous item.3 Hold to finish the procedure.[AUD CTRL] : While listening to any source except in STANDBY state...Item Selectable setting (Preset: *)SW LEVEL SW L –15 — SW L +15 (Preset: SW L 0): Adjusts the subwoofer output level.BASS LVL –8 — +8 (Preset: 0): Source tone memory: Adjusts the level to memorize in each source. (Before making anadjustment, select the source you want to adjust.)MID LVLTRE LVLEQ NATURAL */ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL: Selects a preset sound mode suitable tothe music genre. (Selects [USER] to use the customized bass, middle, and treble settings.)B.BOOST BB-L LV1/ BB-L LV2/ BB-L LV3: Selects your preferred bass boost level. ; BB-L OFF *: Cancels.LOUDNESS LOUD LV1 */ LOUD LV2: Selects your preferred low and high frequencies boost to produce a well-balancedsound at a low volume level. ; LOUD OFF: Cancels.BALANCE BAL L15 — BAL R15 (Preset: BAL 0): Adjusts the left and right speaker output balance.FADER FAD R15 — FAD F15 (Preset: FAD 0): Adjusts the rear and front speaker output balance.SW SET SW ON *: Turns on the subwoofer output. ; SW OFF: Cancels.DTIL SET LPF SW: LPF THRU *: All signals are sent to the subwoofer. ; LPF 85H/ LPF 120H/ LPF 160H:Frequencies higher than 85 Hz/ 120 Hz/ 160 Hz are cut off.SW PHASE: PHAS REV (180°)/ PHAS NML (0°) *: Selects the phase angle of the subwoofer output to be inline with the speaker output for optimum performance. (Selectable only if a setting other than[LPF THRU] is selected for [LPF SW].)SPRM SET: SPRM ON *: Creates realistic sound by interpolating the high-frequency components that arelost in MP3/WMA audio compression. ; SPRM OFF: Cancels. (Selectable only when playbackan MP3/WMA disc or a USB device.)V-OFFSET:(Preset:V-OFF 0)V-OFF –8 — V-OFF +8 (for AUX) ; V-OFF –8 — V-OFF 0 (for other sources): Presetsthe volume adjustment level of each source. The volume level will automatically increase ordecrease when you change the source. (Before making an adjustment, select the source youwant to adjust.)[SW LEVEL/ SW SET/ LPF SW/ SW PHASE] is selectable only if [SWPRE] is set to [SWPRE SW]. (page 6)[SW LEVEL/ LPF SW/ SW PHASE] is selectable only if [SW SET] is set to [SW ON].Function settings