Kenwood KDC-MP102U Instruction Manual

Contents

13ENGLISHInstall this unit in the console of yourvehicle. Make sure the faceplate will not hitthe lid of the console (if any) when closingand opening.After the unit is installed, check whetherthe brake lamps, blinkers, wipers, etc. onthe car are working properly.Mount the unit so that the mounting angleis 30° or less.If the fuse blows, first make sure the wiresaren‘t touching to cause a short circuit,then replace the old fuse with one with thesame rating.Connect the speaker wires correctly to theterminals to which they correspond. Theunit may be damaged or fail to work if youANT CONTP. CONTMUTER LREAR/SWWiring connectionFuse (10 A)Antenna terminalCar fuse boxCar fuse boxBatteryIgnition key switchBlue/White(Power control wire)Red (Ignition wire)Yellow (Battery wire)Black (Ground wire)To the metallic body or chassis of the carTo the power control terminal when using the optional power amplifier, orto the antenna control terminal in the vehicle.Rear/subwoofer outputterminalsBrown(Mute control wire)Blue(Antenna control wire)WhiteGrayGreenPurpleWhite/BlackGray/BlackGreen/BlackPurple/BlackTo the terminal that is grounded when either the telephone rings or duringconversation. (To connect the Kenwood navigation system, consult yournavigation manual.)To front speaker (left)To rear speaker (left)To front speaker (right)To rear speaker (right)(Not used)share the · wires or ground them to anymetal part in the car.When only two speakers are beingconnected to the system, connect theconnectors either to both the front outputterminals or to both the rear outputterminals (do not mix front and rear).Do not touch the metal part of this unitduring and shortly after the use of theunit. Metal part such as the heat sink andenclosure become hot.Mounting and wiring this product requiresskills and experience. For safety‘s sake, leavethis work to professionals.If you experience problems duringinstallation, consult your Kenwood dealer.