6Getting startedCanceling the displaydemonstrationThe display demonstration is always turnedon unless you cancel it.When you turn on the power (or after youreset the unit), the display shows:[CANCEL] \ [DEMO] \ [PRESS] \[VOLUME] \ [KNOB]1 Press the volume knob.[ / N ] is selected as the initial setup.2 Press the volume knob again to confirm.[DEMO OFF] appears.If no operation is done for about 15 secondsor if you turn the volume knob to select[ Y / ] in step 2, [DEMOMODE] appearsand the display demonstration starts.Setting the demonstration mode1 Press the volume knob to enter[FUNCTION] mode.2 Turn the volume knob to select [DEMO],then press to enter.3 Turn the volume knob to select[DEMO ON] or [DEMO OFF].If [DEMO ON] is selected, displaydemonstration starts if no operation isdone for about 20 seconds.4 Hold to finish the procedure.Adjusting the clock1 Press the volume knob to enter[FUNCTION] mode.2 Turn the volume knob to select[SETTINGS], then press to enter.3 Turn the volume knob to select [CLOCK],then press to enter.4 Press the volume knob to select[CLK ADJ].Clock hour flashes on the display.5 Turn the volume knob to adjust the hour,then press to enter minute adjustment.Clock minutes flashes on the display.6 Turn the volume knob to adjust theminute, then press to confirm.Press 4 / ¢ to move between thehour and minute adjustment.7 Hold to finish the procedure.Initial settings before operations1 Press SRC to enter [STANDBY] mode.2 Press the volume knob to enter[FUNCTION] mode.3 Turn the volume knob to select[INITIAL], then press to enter.4 Turn the volume knob to make aselection, then press to confirm.See table below for selection.5 Hold to finish the procedure.Item Selectable setting (Preset: *)PRESET TYPE NML *: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ AM). ;TYPE MIX: Memorizes one station for each preset button regardless of the selected band (FM1/ FM2/ FM3/ AM).KEY BEEP BEEP ON */ BEEP OFF: Activates/deactivates the keypress tone.AUX SET AUX ON *: Enables “AUX” in source selection. Sound of the connected external component is produce through thecar speakers. ; AUX OFF: Disables “AUX” in source selection.CD READ CD READ1 *: Automatically distinguishes between audio file disc and music CD. ; CD READ2: Forces to play as amusic CD. No sound can be heard if an audio file disc is played.SWPRE SWPRE R */ SWPRE SW: Selects whether rear speakers or a subwoofer are connected to the line out terminals onthe rear of the unit (through an external amplifier).SPEAKER SP OFF */ SP 5/4/ SP 6×9/6/ SP OEM: Selects the speaker size for optimum performance.F/W xx.xx / N *: Starts upgrading the firmware. ; Y /: Cancels (upgrading is not activated).For details on how to update the firmware, see: www.kenwood.com/cs/ce/
