Kenwood KDC-MP6090R Instruction Manual

Also see for KDC-MP6090R: Service manual

The panel cannot be reversed when the faceplate is not attached.Opening the control panel:Press the upper side of the faceplate.The faceplate will open.Push the bottom of the control panel and close the faceplate.Whilst the control panel is sliding, only available buttons are 0,ATT, s, t and SRC.NOTE21NOTEbracket to be deformed.• Do not touch the connector on the faceplate bracket afterremoving the faceplate. Touching the connector may causedamage to the unit.• The faceplate is a precision piece of equipment and can bedamaged by shocks or jolts. For that reason, keep the faceplatein its special storage case whilst detached.• Do not expose the faceplate or its storage case to directsunlight or excessive heat or humidity. Also avoid places withtoo much dust or the possibility of water splashing.Reattaching the Faceplate:Hold the faceplate so that the control panel faces the fronttoward you and set the left side of the faceplate in thefaceplate bracket.Do not set the right side of the faceplate in the faceplate bracketfirst, when reattaching the faceplate. Doing so may cause theconnector on the faceplate bracket to malfunction.Press the right side of the faceplate until it locks.Hiding the control panel:Press the release button and slide open the faceplate.Push upward the back of the control panel and reverse thepanel.2122CAUTION1NOTE— 13 —