Kenwood KDC-MP6090R Instruction Manual

Also see for KDC-MP6090R: Service manual

English— 44 —What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring.Before calling service, first check the following table for possible problems.Troubleshooting GuideSOLUTIONPOSSIBLE CAUSEPROBLEMA speaker cable may be pinched by a screw in the car. Check the speaker wiring.No sound can be heard, or thevolume is low.The fader and/or balance settings are set all the way toone side.Reset the fader and/or balance settings.The input/output cables or wiring harness are connectedincorrectly.Reconnect the input/output cables and/or the wiringharness correctly. See the section on "ConnectingCables to Terminals".Nothing happens when thebuttons are pressed.The computer chip in the unit is not functioning normally. Press the reset button on the unit (see page 4).The sound quality is poor ordistorted.The speakers are not wired correctly. Reconnect the speaker cables so that each outputterminal is connected to a different speaker.The antenna control cable is not connected. Connect the cable correctly, referring to the section on"Connecting Cables to Terminals".Radio reception is poor. The car antenna is not extended. Pull out the antenna all the way.The power does not turn on. The fuse has blown. After checking for short circuits in the cables, replacethe fuse with one having the same rating.The Attenuator function is turned on. Turn off the Attenuator function.No ACC position on vehicle ignition. Connect the same cable to the ignition as the battery cable.The memory is erased whenthe ignition is turned off.The battery cable has not been connected to the properterminal.Connect the cable correctly, referring to the section on"Connecting Cables to Terminals".The TEL mute function doesnot work.The TEL mute cable is not connected properly. Connect the cable correctly, referring to the section on"Connecting Cables to Terminals".The ignition and battery cable are incorrectly connected. Connect the cable correctly, referring to the section on"Connecting Cables to Terminals".The TEL mute function turnson even though the TEL mutecable is not connected.The TEL mute cable is touching a metal part of the car. Pull the TEL mute cable away from the metal part of thecar.The values of Volume offset are low. Increase the values of Volume offset. (see p. 11)If you have selected Standbymode, the power will go OFFautomatically.The Power Off Timer function has been activated. If you do not want the power to go OFF automatically,cancel the Power Off Timer function.