English|13• Dual Zone SystemMain source and sub source (Auxiliary input) outputFront channel and Rear channel separately.- Set up the channel of sub source by System Setting> (page 45).- Select Main source by [SRC] button.- Adjust the volume of Front channel by [VOL] knob.- Adjust the volume of Rear channel by Control> (page 11).- The Audio Control has no effect on sub source.• You can use the Dual Zone System with the Auxiliaryinput sources listed below.- Internal auxiliary input5Exit Audio Setup modePress the [VOL] knob for at least 1 second.Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2Enter Speaker Setting modePress the [VOL] knob."SP SEL" is displayed.3Select the Speaker typeTurn the [VOL] knob.Each time you turn the knob, the settingalternates between the settings shown in thetable below.Speaker typeDisplayOFF"OFF"For 5 & 4 in. speaker"5/4 inch"For 6 & 6x9 in. speaker"6x9/6 inch"For the OEM speaker"O.E.M."4Exit Speaker Setting modePress the [VOL] knob.Subwoofer OutputTurning the Subwoofer output ON or OFF.Push the Control knob toward [AM] for atleast 2 seconds.Each time you push the knob, Subwoofer outputswitches ON and OFF.When it is ON, "SW ON" is displayed.• You can control this function when "2 ZONE" ofTEL MuteThe audio system automatically mutes when acall comes in.When a call comes in"CALL" is displayed.The audio system pauses.Listening to the audio during a callPress the [SRC] button.The "CALL" display disappears and the audiosystem comes back ON.When the call endsHang up the phone.The "CALL" display disappears and the audiosystem comes back ON.• To use the TEL Mute feature, you need to hook upthe MUTE wire to your telephone using a commercialtelephone accessory. Refer to Terminals> (page 56).Faceplate Angle AdjustmentPress the [ANG] button for at least 1 second.• Do not apply excessive force to the faceplate. It cancause damage.
