Kenwood KDC-U4549SD Instruction Manual

Also see for KDC-U4549: Service manual

English 25Item Selectable setting (Preset: *)PAIRINGDEVICE SEARCH Registers a Bluetooth device (pairing).(For details, see page 23.)PHONE SELECT Selects a cell-phone connection.(For details, see page 24.)AUDIO SELECT KDC-U4549SD/ KDC-U4549 only:Selects a Bluetooth audio player connection. (For details, see page 24.)S-DVC SELECT (For details, see page 23.)DEVICE DELETE Cancel registration of the Bluetooth device.1. Turn the volume knob to select the Bluetooth device, then press to confirm.2. Turn the volume knob to select “YES”, then press to confirm.SMS DOWNLOAD Download a short message. (For details, see page 27.)VOICE TAGPB NAME EDIT Registers voice for voice recognition and voice to select the Phone number category in Phone book.(For details, see page 24.)PN TYPE EDITDETAILED SETPIN CODE EDIT Specify the PIN code required when registering this unit using the Bluetooth device. By default, “0000” isspecified.1. Turn the volume knob to select the number.■ To move to the next digit, press ¢.■ To delete the last digit, press 4.2. Press the volume knob to register a PIN codeAUTO ANSWER OFF: Does not answer the phone call automatically. ; 0: Automatically answers the phone call at once. ;1 – 8 * –99: Automatically answers the phone call after lapse of 1 – 99 seconds.then press to confirm. (KDC-U4549SD/KDC-U4549 only)7 “ENTER 1” is displayed. When a beep isheard, say a voice tag within 2 seconds.8 “ENTER 2” is displayed. When a beep isheard, say the same voice tag as that yousaid in step 7 within 2 seconds.“COMPLETE” is displayed.9 Press the volume knob to return to step5.■ Set the voice tag for all the 5 categories. Ifthe voice tag is not registered for all thecategories, the Phone book may not berecalled by voice command.Bluetooth Setup1 KDC-U549BTPress to enter Bluetooth mode.KDC-U4549SD / KDC-U4549Press and hold the volume knob to enterBluetooth mode.2 Turn the volume knob to select[SETTINGS], then press to enter.3 Turn the volume knob to make aselection, then press to confirm.■ See table below for selection.■ Repeat step 3 until the desired item isselected/activated.■ Press to return to the previous item.4 Hold to finish the procedure.■ To exit Bluetooth mode, press SRC.Continued to next page