8 EnglishGetting StartedCanceling the displaydemonstrationThe display demonstration is always turnedon unless you cancel it.When you turn on the power (or after youreset the unit), the display shows:[CANCEL DEMO] \ [PRESS] \ [VOLUMEKNOB]1 Press the volume knob.[YES] is selected as the initial setup.2 Press the volume knob again to confirm.[DEMO OFF] appears.■ If no operation is done for about 15 secondsor if you turn the volume knob to select[NO] in step 2, [DEMO MODE] appears andthe display demonstration starts.Setting the demonstration mode1 Press the volume knob to enter[FUNCTION].2 Turn the volume knob to select [DEMOMODE], then press to enter.3 Turn the volume knob to select [ON] or[OFF].If [ON] is selected, display demonstrationstarts if no operation is done for about 20seconds.4 Hold to finish the procedure.Adjusting the clock1 Press the volume knob to enter[FUNCTION] mode.2 Turn the volume knob to select[SETTINGS], then press to enter.3 Turn the volume knob to select [CLOCK],then press to enter.4 Turn the volume knob to select [CLOCKADJUST], then press to enter.Clock hour flashes on the display.5 Turn the volume knob to adjust the hour,then press to enter minute adjustment.Clock minutes flashes on the display.6 Turn the volume knob to adjust theminute, then press to confirm.Press 4 / ¢ to move between thehour and minute adjustment.7 Hold to finish the procedure.Muting upon the reception of a phone call (KDC-U4549SD/ KDC-U4549only)To use this feature, connect the MUTE lead to your telephone using a commercial telephoneaccessory. (See “Installation Manual” on a separate volume.)When a call comes in, “CALL” appears.■ The audio system pauses.■ To continue listen to the audio system during a call, press SRC. “CALL” disappear and theaudio system resumes.When a call ends, “CALL” disappear.■ The audio system resumes.