Kenwood KDC-U4549SD Instruction Manual

Also see for KDC-U4549: Service manual

28 EnglishFunction settings1 Press SRC to select a source other than “STANDBY”.2 Press the volume knob to enter [FUNCTION] mode.3 Turn the volume knob to select [AUDIO CONTROL] or [SETTINGS], then press to enter.4 Turn the volume knob to make a selection, then press to confirm.■ See table below for selection.■ Repeat step 3 until the desired item is selected/activated.■ Press to return to the previous item.5 Hold to finish the procedure.[AUDIO CONTROL] : While listening to any source except in STANDBY state or Bluetooth mode.Item Selectable setting (Preset: *)SUB-W LEVEL –15 — 0 * — +15: Adjusts the subwoofer output level.BASS BOOST B.BOOST LV1 */ B.BOOST LV2: Selects your preferred bass boost level. ; OFF: Cancels.SYSTEM Q NATURAL */ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ GAME: Selects a preset sound mode suitable to themusic genre. (Selects [USER] to use the customized bass, middle, and treble settings.)BASS ADJUSTBASS CTR FRQ 40/ 50/ 60/ 70/ 80/ 100 */ 120/ 150: Selects the center frequency.BASS LEVEL –8 — 0 * — +8: Adjusts the level.BASS Q FACTOR 1.00 */ 1.25/ 1.50/ 2.00: Adjusts the quality factor.BASS EXTEND ON: Turns on the extended bass. ; OFF *: Cancels.MID ADJUSTMID CTR FRQ 0.5K/ 1.0K/ 1.5K/ 2.0K *: Selects the center frequency.MID LEVEL –8 — 0 * — +8: Adjusts the level.MID Q FACTOR 1.00 */ 2.00: Adjusts the quality factor.TRE ADJUSTTRE CTR FRQ 10.0K/ 12.5K */ 15.0K/ 17.5K: Selects the center frequency.TRE LEVEL –8 — 0 * — +8: Adjusts the level.BALANCE L15 — 0 * — R15: Adjusts the left and right speaker output balance.FADER R15 — 0 * — F15: Adjusts the rear and front speaker output balance.SUBWOOFER SET ON *: Turns on the subwoofer output. ; OFF: Cancels.DETAILED SETHPF FRONT THROUGH *: All signals are sent to the front speaker. ; 40/60/80/100/ 120/150/180/220 (HZ): Frequencieslower than the specified value are cut off.HPF REAR THROUGH *: All signals are sent to the rear speaker. ; 40/60/80/100/ 120/150/180/220 (HZ): Frequencieslower than the specified value are cut off.LPFSUBWOOFERTHROUGH *: All signals are sent to the subwoofer. ; 50/60/80/100/120 (HZ): Frequencies higher than thespecified value are cut off.SUB-W PHASE REVERSE (180°)/ NORMAL (0°) *: Selects the phase angle of the subwoofer output to be in line with thespeaker output for optimum performance. (Selectable only if a setting other than [THROUGH] is selected for[LPF SUBWOOFER].)