Kenwood KDC-U7053BT Instruction Manual

Also see for KDC-U7053BT: Quick start guide

English | 21Initial settingsYou can configure initial settings of this unit.1 Select the StandbyPress the [SRC] button.Select the “STANDBY” display.2 Enter the Function setting modePress and hold the Control knob.3 Select the Initial settings itemTurn the Control knob to select “Initial Settings”,and then press the Control knob.4 Select a desired Initial setting itemTurn the Control knob to select an Initial settingitem, and then press the Control knob.Display Description“Initial Settings”“SRC Select” Select “2” to change the source selectionmethod. Press the [SRC] button, turn theControl knob to select the source, and thenpress the Control knob to determine it.1 / 2“Key Beep” Setting the operation check sound (beepsound) ON/OFF.“ON” / “OFF”“TDF Alarm” If you turn off the engine key of the vehiclewithout removing the panel, a beep soundsfor 30 seconds.“ON” / “OFF”“Chinese” When this is set to ON, the following characterstrings are displayed in Chinese:Folder name/ File name/ Song title/ Artistname/ Album name(KDC-U7053BT only)“ON” / “OFF”“TAG Language” When this is set to “Arabic”, ”Persian”, or “Thai”,the following character strings are displayed inArabic, Persian, or Thai:Folder name/ File name/ Song title/ Artistname/ Album name(KDC-U7053BTL only)English / Arabic / Persian / Thai“Function Language” Changes the display language of itemsdisplayed in the Function setting mode.(KDC-U7053BTL only)English / Persian“Built-in AUX” Sets whether to display AUX during sourceselection.“ON” / “OFF”“CD Read” Sets the method for reading CD.When unable to play a special format CD, setthis setting to “2” to force playing. Note thatsome music CDs may be unplayable evenwhen set to “2”.In addition, audio files cannot be played whenset to “2”. Normally, keep this set to “1”.1: Automatically distinguishes between theaudio file disc and music CD when playinga disc.2: Forces playing as a music CD.“Built-in AMP” Selecting “OFF” turns off the built-in amplifier.Turning off the built-in amplifier improves thequality of the sound from Preout.“ON” / “OFF”“Speaker Select” Sets the speaker type so that the System Qvalue is optimal.“OFF”: OFF“5/4inch”: For 5 & 4 in. speaker“6x9/6inch”: For 6 & 6x9 in. speaker“O.E.M.”: For the OEM speaker“F/W Update” Upgrades the firmware.Selecting “YES” and then pressing the Controlknob starts upgrading the firmware.For how to update the firmware, access ourweb site.http://www.kenwood.com/cs/ce/( : Factory setting)5 Select an Initial setting itemTurn the Control knob to select desired setting,and then press the Control knob.The previous item is displayed.6 Exit the Function setting modePress and hold the [ ] button.