Kenwood KDC-U7053BT Instruction Manual

Also see for KDC-U7053BT: Quick start guide

English | 37The messages shown below indicates yoursystem condition.“TOC Error”• The CD is quite dirty. The CD is upside-down. The CD isscratched a lot.• The disc is unreadable.“IN” (blink)• The CD player section is not operating properly.➪ Reinsert the CD. If the CD cannot be ejected or thedisplay continues to blink even when the CD hasbeen properly reinserted, please switch off the powerand consult your nearest service center.“Protect” (blink)• The speaker wire has short-circuited or touched thechassis of the vehicle, and then the protection functionhas been activated.➪ Lay or insulate the speaker cable properly and pressthe Reset button. If “Protect” does not disappear,consult your nearest service center.“NA File”• An Audio file is played in a format that is not supportedby this unit.“Copy PRO”• A copy-protected file is played.“Read Error”• The file system of the connected USB device is broken.➪ Copy the files and folders for the USB device again. If“Read Error” is still displayed, initialize the USB deviceor use another USB device.“No Device”• A USB device is selected as a source although no USBdevice is connected.➪ Change the source to any source other than theUSB device. Connect an USB device, and change thesource to the USB device again.“N/A Device”• An unsupported USB device is connected.• Connection to the iPod has failed.➪ Check that the connected iPod is supported. See (page 34) for informationon supported iPods.“No Music Data”• The connected USB device contains no playable audiofile.• A medium that does not have playable data has beenplayed.“iPod Error”• Connection to the iPod has failed.➪ Remove the USB device and then reconnect it.➪ Reset iPod/ iPhone.“No Number”• The calling party does not notify a caller ID.• There is no phone number data.“No Data”• There is no outgoing call list.• There is no incoming call list.• There is no missed call list.• There is no phone book list.“No Entry”• The cell-phone has not been registered (pairing).“HF Disconnect”• The unit cannot communicate with the cell-phone.“AUD Disconnect”• The unit cannot communicate with the Bluetooth audioplayer.“HF Error 07”• The memory cannot be accessed.➪ Cycle the power switch. If this message still appears,press the Reset button on the control unit.“HF Error 68”• The unit cannot communicate with the cell-phone.➪ Cycle the power switch. If this message still appears,press the Reset button on the control unit.“HF Error 89”• Update of the firmware has failed.➪ Retry update of the firmware.“Unknown”• The Bluetooth device cannot be detected.“Device Full”• 5 Bluetooth device have already been registered. No moreBluetooth devices are registered.“PIN Code NG”• The PIN code is wrong.“Connect NG”• The unit cannot be connected to the device.“Pairing Failed”• Pairing error.“N/A Voice Tag”• No voice tags are registered in your cell-phone.“No Phonebook”• Data is not contained in the phone book.“No Message”• No short message in In Box.“Send Error”• SMS could not be sent.“No Support”• The connected Bluetooth device does not support avoice recognition function.“No Active Device”• Any Bluetooth device supporting a voice recognitionfunction is not connected.

/ 40

Related manuals for Kenwood KDC-U7053BT