60|KDC-U7056DAB/ KDC-U7056BT/ KDC-U7056BTLEnglish|61General settings12-5. Initial settingsYou can configure initial settings of this unit.1Press [SRC] to select a Standby (“STANDBY”).Refer to (page 10).2Press [Control] knob.Enters the Function setting mode.3Select “Initial Settings” using [Control] knob.For how to use [Control] knob, refer to <3-3. Howto select the item> (page 9).4Select an Initial setting item using [Control]knob.DisplayDescription“SRC Select”Set source selection method.“1”: The source switches each time [SRC] ispressed.“2”: Press [SRC], Turn [Control] knob to selectthe source, and then press [Control] knob todetermine it.“Key Beep”[4]Setting the operation check sound (beepsound) ON/OFF.“ON”/ “OFF”“TDF Alarm”[4]If you turn off the engine key of the vehiclewithout removing the panel, a beep soundsfor 30 seconds.“ON”/ “OFF”“Chinese”[1]When this is set to ON, the following characterstrings are displayed in Chinese:Folder name/ File name/ Song title/ Artistname/ Album name“ON”/ “OFF”“TAG Language”[2]When this is set to“Arabic”, ”Persian”, or“Thai”,the following character strings are displayed inArabic, Persian, or Thai:Folder name/ File name/ Song title/ Artistname/ Album nameEnglish / Arabic / Persian / Thai“Function Language”[2]Changes the display language of itemsdisplayed in the Function setting mode.English / Arabic / Persian“Pandora Source”[1][3]Sets whether to display Pandora during sourceselection.“ON”/ “OFF”“aha Source”Sets whether to display aha during sourceselection.“ON”/ “OFF”“Built-in AUX”Sets whether to display AUX during sourceselection.“ON”/ “OFF”“CD Read”Sets the method for reading CD.When unable to play a special format CD, setthis setting to“2”to force playing. Note thatsome music CDs may be unplayable evenwhen set to“2”.In addition, audio files cannot be played whenset to“2”. Normally, keep this set to“1”.1: Automatically distinguishes between theaudio file disc and music CD when playinga disc.2: Forces playing as a music CD.“Built-in AMP”Selecting“OFF”turns off the built-in amplifier.Turning off the built-in amplifier improves thequality of the sound from Preout.“ON”/ “OFF”“F/W Update”Upgrades the firmware.Selecting“YES”and then pressing [Control]knob starts upgrading the firmware.For how to update the firmware, access ourweb site.http://www.kenwood.com/cs/ce/(Colored text: Factory setting)[1]Function of KDC-U7056BT.[2]Function of KDC-U7056BTL.[3]Function of KDC-U7056DAB.[4]Not displayed while using 3 way system.5Select a setting using [Control] knob.Returns to the previous item.Exiting from the Function setting modePress and hold [1/6].
