Kenwood KDC-X5100BT Instruction Manual

Contents

ENGLISH 3BASICSTo On the faceplateTurn on the power Press .• Press and hold to turn off the power.Adjust the volume Turn the volume knob.Select a source Press repeatedly.Change the display information Press DISP repeatedly. ( 25)FaceplateHow to resetAttach DetachSelect the display language and cancel thedemonstrationWhen you turn on the power for the first time(or [FACTORY RESET] is set to [YES], 5), the display shows:“SEL LANGUAGE” “PRESS” “VOLUME KNOB”1 Turn the volume knob to select [ENG] (English), [RUS](Russian) or [SPA] (Spanish), then press the knob.[ENG] is selected for the initial setup.Then, the display shows: “CANCEL DEMO” “PRESS”“VOLUME KNOB”.2 Press the volume knob.[YES] is selected for the initial setup.3 Press the volume knob again.“DEMO OFF” appears.Then, the display shows the selected crossover type:“2-WAY X ’ OVER” or “3-WAY X ’ OVER”• To change the crossover type, see “Change the crossovertype”. ( 5)GETTING STARTED1VolumeknobDetachbuttonDisplaywindowLights up when Bluetoothconnection is established. ( 10)Flashes when the unitenters searching status.USB cable from therear of the unit.Auxiliary cable fromthe rear of the unit.