Kenwood KDC-X700DAB Instruction Manual

Contents

12BLUETOOTH®You can operate Bluetooth devices using this unit.Connect the microphoneIf you turn off the unit or detach the control panelduring a phone call conversation, the Bluetoothconnection is disconnected. Continue theconversation using your mobile phone.Supported Bluetooth profiles– Hands-Free Profile (HFP)– Serial Port Profile (SPP)– Phonebook Access Profile (PBAP)– Object Push Profile (OPP)– Advanced Audio Distribution Profile (A2DP)– Audio/Video Remote Control Profile (AVRCP)Adjust the microphoneangle Secure using cord clamps (notsupplied) if necessary.MIC (Microphone input terminal)Microphone (supplied)Rear panel• Pairing request (via Bluetooth) isautomatically activated if an iPhone/iPodtouch is connected through the USB inputterminal. (Applicable only if [AUTO PAIRING] isset to [ON].) ( 16)Press the volume knob to pair once youhave confirm the device name.Bluetooth test modeYou can check the connectivity of thesupported profile between the Bluetoothdevice and the unit.• Make sure there is no Bluetooth deviceconnected.1 Press and hold .“PLEASE PAIR YOUR PHONE” appears.2 Search and select this unit model name(KDC-X7**DAB) on the Bluetooth device.3 Operate the Bluetooth device to confirmpairing.“TESTING” flashes on the display.The connectivity result (OK or NG) appearsafter the test.PAIRING: Pairing statusHF CNT: Hands-Free Profile (HFP)compatibilityAUD CNT: Advanced Audio DistributionProfile (A2DP) compatibilityPB DL: Phonebook Access profile (PBAP)compatibility• To cancel check mode, press and holdB SRC to turn off the unit.Pair a Bluetooth deviceWhen connecting a Bluetooth device tothe unit for the first time, perform pairingbetween the unit and the device. Once thepairing is completed, the Bluetooth devicewill remain registered in the unit even if youreset the unit.• Up to five devices can be registered (paired)in total.• A maximum of two Bluetooth phonesand one Bluetooth audio device can beconnected at any time.• This unit supports Secure Simple Pairing(SSP).• Some Bluetooth devices may notautomatically connect to the unit afterpairing. Connect the device to the unitmanually. Refer to the instruction manual ofthe Bluetooth device for more information.1 Press B SRC to turn on the unit.2 Search and select this unit model name(KDC-X7**DAB) on the Bluetooth device.“PAIRING” “PASS XXXXXX” Devicename “PRESS” “VOLUME KNOB”scrolls on the display.3 Press the volume knob to start pairing.“PAIRING OK” appears when pairing iscompleted and “ ” will light up when theBluetooth connection is established.• For some Bluetooth devices, you may needto enter the Personal Identification Number(PIN) code immediately after searching.