55 | KDC-X996/ KDC-BT952HD English | 56Bluetooth SetupBluetooth SettingYou can select following Bluetooth Setting items.1 Enter Bluetooth modePress the [ ] button.✍ You can also select from “Settings” in Menu Listmode.2 Turn the [VOL] knob and press it when thedesired item is displayed.Select “BT Settings”.3 Select the Menu itemTurn the [VOL] knob and press it when thedesired item is displayed.Display Overview“SMS Inbox” Display the received short message.Refer to (page 61).“BT Settings”“Pairing”“Device Regist.” Register a Bluetooth device (pairing).Refer to (Pairing)> (page 57).“PhoneSelection”Select a cell-phone or Bluetooth audio playerconnectionRefer to Wish to Connect> (page 58).“Audio Selection”“SPCL DVCSelect”Register a Bluetooth device (pairing).Refer to (Pairing)> (page 57).“Device Delete” Cancel registration of the Bluetooth device.Refer to device> (page 59).“SMS”“SMSDownload”Download a short message.Refer to (page61).“SMS Reply” Select a method to reply to the received SMS.Refer to (page 62).“SMS Message” Create an original message.Refer to (page 63).“Detailed Setup” Move to detailed item.“PIN Code Edit” Specify the PIN code required when registeringthis unit using the Bluetooth device.Refer to (page 58).“Auto Answer” Answer a call automatically after lapse of thepreset time interval for automatic answer.“OFF”/ “0s” – “8s” – “99s”“AutoReconnect”Automatically reconnects the selectedBluetooth device when radio wave becomesstrong enough, even after it is disconnected.“ON”/ “OFF”✍ When this function is turned ON, the Bluetooth deviceis reconnected if it has been disconnected by selecting“Phone Selection”/ “Audio Selection”.“Bluetooth HF/Audio”You can specify output speakers for hands-freevoice communication and Bluetooth audiosound.“Front”: Outputs audio from the front speakers.“All”: Outputs audio from the front and rearspeakers.“Call Beep” You can output a beep from the speaker whena call comes in.“ON”: Beep is heard.“OFF”: Beep is canceled.“BT F/W Update” Display the version of the firmware of this unit.“Mic Gain” Adjust the sensitivity of the microphone for atelephone call. Adjust the voice of caller. Settingto “+” increases the voice volume.“1” – “20” – “30”“NR Level” Reduce the noises generated by surroundingenvironment without changing the microphonevolume. Adjust the voice of caller when it isnot clear. Setting to “+” increases the noisereduction.“–1” – “0” – “+1”“Echo CancelLevel“Adjust the level of echo cancellation. Setting to“+” increases the echo cancel reduction.“–1” – “0” – “+1”( : Factory setting)4 Make a settingTurn the [VOL] knob to select a setting value,and then press the [VOL] knob.5 Exit BT Settings modePress the [ ] button.4MENU VOL¢Remarks• “Auto Answer” (Setting the Time Interval for AutomaticAnswer)This function automatically answers (responds to) a callafter lapse of the preset time interval for automatic answer.“OFF” : Does not answer the phone call automatically.“0” : Automatically answers the phone call at once.“1s” – “99s” : Automatically answers the phone call afterlapse of 1 – 99 seconds.⁄• If the time set in the cell-phone is shorter than that set inthe unit, the former will be used.• This function does not work for call waiting.• “BT F/W Update” (Displaying the Firmware Version)Display the version of the firmware of this unit.For how to update the firmware, access our web site.http://www.kenwood.com/cs/ce/bt/
