Kenwood KMM-BT505DAB Instruction Manual

Also see for KMM-BT505DAB: Quick start guide

ENGLISH 29Symptom RemedyGeneralSound cannot be heard. • Adjust the volume to the optimum level.• Check the cords and connections.“MISWIRING CHECK WIRINGTHEN PWR ON” appears.Turn the power off, then check to be sure the terminals ofthe speaker wires are insulated properly. Turn the poweron again.“PROTECTING SEND SERVICE”appears.Send the unit to the nearest service center.Source cannot be selected. Check the [SOURCE SELECT] setting. (Page 4)• Sound cannot be heard.• The unit does not turn on.• Information shown on thedisplay is incorrect.Clean the connectors. (Page 27)The unit does not work at all. Reset the unit. (Page 3)Correct characters are notdisplayed.• This unit can only display uppercase letters, numbers,and a limited number of symbols.• Depending on the display language you have selected(page 5), some characters may not be displayedcorrectly.Digital RadioDAB reception is poor. Make sure [ON] is selected for [DAB ANT POWER].(Page 4)“DAB ANT ERR” Check the DAB antenna. If a passive antenna (withouta booster) is used, set [DAB ANT POWER] to [OFF].(Page 4)“RELATED SERV FOUND” • Press the volume knob to activate Soft-Link. (Page 7)• Press to cancel.TROUBLESHOOTINGSymptom RemedyAnalogRadio • Radio reception is poor.• Static noise while listeningto the radio.Connect the antenna firmly.USB/iPodPlayback order is not asintended.The playback order is determined by the order in whichfile name were recorded (USB).Elapsed playing time is notcorrect.This depends on the recording process earlier (USB).“READING” keeps flashing. • Do not use too many hierarchical levels and folders.• Reattach the device (USB/iPod/iPhone).“UNSUPPORTED DEVICE”appears.• Check whether the connected USB device is compatiblewith this unit and ensure the file systems are insupported formats. (Page 27)• Reattach the USB device.“UNRESPONSIVE DEVICE”appears.Make sure the USB device is not malfunction andreattach the USB device.“USB HUB IS NOTSUPPORTED” appears.This unit cannot support a USB device connected via aUSB hub.• The source does notchange to “USB” whenyou connect a USB devicewhile listening to anothersource.• “USB ERROR” appears.The USB port is drawing more power than the designlimit. Turn the power off and unplug the USB device.Then, turn on the power and reattach the USB device.If this does not solve the problem, turn the power offand on (or reset the unit) before replacing with anotherUSB device.The iPod/iPhone does notturn on or does not work.• Check the connection between this unit and iPod/iPhone.• Disconnect and reset the iPod/iPhone using hard reset.“LOADING” appears whenyou enter search mode bypressing .This unit is still preparing the iPod/iPhone music list. Itmay take some time to load, try again later.