English | 15 Audio Preset Memory Registering the values setup within Sound Controls. These settings cannot be erased by the Reset button. 1 Setup Sound Control Refer to the following operations to setup the Sound Control. - (page 14) - (page 14) - (page 14) 2 Select Audio Preset item Select the “Audio Preset” display. For how to select Menu items, refer to System> (page 8). 3 Enter Audio Preset mode Press the [ENTER] button for at least 1 second. “Recall” is displayed. 4 Select the Audio Preset Memory Turn the [VOL] knob. Select the “Memory” display. 5 Determine whether to put the Audio Preset in the memory Press the [ENTER] button. “Memory?” is displayed. 6 Put the Audio Preset in the memory Turn the [VOL] knob to select “YES”, and then press the [ENTER] button. “Memory Completed” is displayed. 7 Exit Audio Preset mode Press the [ ] button. ⁄ • The memory only holds one audio setting and not settings for each source. • The following items cannot be registered. Volume, Balance, Fader, Loudness, Volume offset, Dual Zone System, Rear Volume Audio Preset Recall Recalling the sound setup registered by Preset Memory> (page 15). 1 Select the source For how to select source item, refer to function> of (page 6). 2 Select Audio Preset item Select the “Audio Preset” display. For how to select Menu items, refer to System> (page 8). 3 Enter Audio Preset mode Press the [ENTER] button for at least 1 second. 4 Select the Audio Preset Recall Turn the [VOL] knob. Select the “Recall” display. 5 Determine whether to recall the Audio Preset Press the [ENTER] button. “Recall?” is displayed. 6 Recall the Audio Preset Turn the [VOL] knob to select “YES”, and then press the [ENTER] button. “Recall Completed” is displayed. 7 Exit Audio Preset mode Press the [ ] button. ⁄ • The User memory of “System Q” in (page 14) is changed to the value which was recalled. • The source tone memory item of (page 14) is changed to the value which was recalled by the selected source. 4 Adjust the Audio setup item Press the [ ] or [ ] button. 5 Exit Audio Setup mode Press the [ENTER] button. Previous Next