Kenwood KMR-700U Instruction Manual

Also see for KMR-700U - Radio / Digital Player: Manual Brochure & specs Instruction manual

English | 27The messages shown below display yoursystems condition.Protect (Blink):The speaker wire has a short-circuit ortouches the chassis of the vehicle, and thenthe protection function is activated.➪ Wire or insulate the speaker cable properlyand press the reset button. If the “Protect”code does not disappear, consult yournearest service center.No Device: The USB device is selected as a sourcealthough no USB device is connected.➪ Change the source to any source otherthan USB. Connect an USB device, andchange the source to USB again.N/A Device: • An unsupported USB device is connected.• Connection to the iPod has failed.➪ Check that the connected iPod is an iPodthat is supported. See (page 21) for information on supportediPods.No Music Data/No Music:• The connected USB device contains noplayable audio file.• Media was played that does not have datarecorded that the unit can play.USB Error: Some trouble may have occurred to theconnected USB device.➪ Remove the USB device, then cycle thepower switch to ON. If the same display isrepeated, use another USB device.REMO ERROR: Some trouble may have occurred to theconnected Remoto control.➪ Remove the Remoto control and thenreconnect it.USB REMOVE (Blink):The Remove mode has been selected for theUSB device. You can remove the USB devicesafely.iPod REMOVE (Blink):The Remove mode has been selected for theiPod. You can remove the iPod safely.FAV : No Memory:The procedure is not registered to FavoritePreset MemoryNO ACCESS: The procedure preset with Favorite Controlcannot be available. The preset content maynot be recalled depending on the selectedsource or mode.

/ 28

Related manuals for Kenwood KMR-700U - Radio / Digital Player

Kenwood KMR-700U Instruction Manual

Kenwood KMR-330 Instruction Manual

This manual is suitable for:

KMR-700U - Radio / Digital Player

manualsdatabase

Your AI-powered manual search engine