Kenwood KMR-700U Instruction Manual
Also see for KMR-700U - Radio / Digital Player: ManualBrochure & specsInstruction manual
                            | |
Contents
|
English | 23Accessories/ Installation ProcedureAccessories1..........12..........13..........74..........25..........16..........1Installation Procedure1. To prevent a short circuit, remove the key from theignition and disconnect the - battery.2. Make the proper input and output wireconnections for each unit.3. Connect the speaker wires of the wiring harness.4. Connect the wiring harness wires in the followingorder: ground, battery, ignition.5. Connect the wiring harness connector to the unit.6. Install the unit in your vessel.7. Reconnect the - battery.8. Press the reset button.2WARNINGIf you connect the ignition wire (red) and the battery wire(yellow) to the negative ground point, you may cause a shortcircuit, that in turn may start a fire. Always connect thosewires to the power source running through the fuse box.¤• Mounting and wiring this product requires skills andexperience. For safety’s sake, leave the mounting and wiringwork to professionals.• Make sure to ground the unit to a negative 12V DC powersupply.• Do not install the unit in a spot exposed to direct sunlightor excessive heat or humidity.• Do not use your own screws. Use only the screws provided.If you use the wrong screws, you could damage the unit.• If the power is not turned ON (“Protect” is displayed), thespeaker wire may have a short-circuit or touched thechassis of the vehicle and the protection function mayhave been activated. Therefore, the speaker wire should bechecked.• If your vessel ignition does not have an ACC position,connect the ignition wire to a power source that can beturned on and off with the key or other control switch. Ifthe receiver is left on for an extended period of time thebattery may die.• If the fuse blows, first make sure the wires aren’t touchingto cause a short circuit, then replace the old fuse with onewith the same rating.• Insulate unconnected wires with vinyl tape or other similarmaterial. To prevent a short circuit, do not remove the capson the ends of the unconnected wires or the terminals.• Connect the speaker wires correctly to the terminals towhich they correspond. The unit may be damaged or fail towork if you share the - wires or ground them to any metalpart in the vessel.• When only two speakers are being connected to thesystem, connect the connectors either to both the frontoutput terminals or to both the rear output terminals (donot mix front and rear). For example, if you connect the +connector of the left speaker to a front output terminal, donot connect the - connector to a rear output terminal.• After installing the unit, check to make sure that electricalequipment such as the signal lamps and gauges operatenormally.• Mount the unit so that the mounting angle is 30° or less. |
Related manuals for Kenwood KMR-700U - Radio / Digital Player
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine