Kenwood KMR-M506DAB Instruction Manual

Also see for KMM-BT506DAB: Quick start guide Instruction manual Instruction manual Quick start guide

34 ENGLISHConnect external componentsNo Part1 Microphone input jack (Page 17)2 Output terminalsFRONT: Front output (2-way crossover) / Mid Range output (3-way crossover)REAR/SW: Rear/subwoofer output (2-way crossover) / Woofer output (3-way crossover)• When connecting an external amplifier to the output terminals of this unit, securelyconnect the amplifier ground wire to the car chassis to prevent damage to the unit.3 DAB antenna jack (Page 7, 37)Installation/ConnectionInstalling the DAB antennaConnect the DAB antenna to the DAB antenna jack. (See the left column.)• DAB antenna is supplied for .For details, see the following.• For , you need to purchase the DAB antenna separately.For details, refer to the instruction manual supplied with the DAB antenna.CAUTION• The film antenna (F) is exclusively for use inside the vehicle.• Do not install at the following locations:– where it may block the driver’s view.– where it may obstruct the operation of safety devices such as air bags.– on movable glass surfaces such as the rear hatch.– at side of vehicle (e.g. door, front quarter window).– on rear window.• Signal strength will weaken when installed at the following locations:– on IR reflecting glass or locations covered with mirror type glass film.– where it overlaps with genuine radio antenna (pattern).– where it overlaps with window heating wires.– on glass that blocks radio signals (e.g. IR reflecting glass, thermalinsulation glass).• Poor reception may occur:– due to noise when windscreen wiper, air conditioner, or motor is turnedon.– depending on the direction of the broadcast station with respect to thevehicle (antenna).• Thoroughly wipe oil and dirt from the pasting surface with the suppliedcleaner (I).• Do not bend or damage the film antenna (F).• It may not be possible to install on certain vehicles.• Check the cable routing of the film antenna (F) and amplifier unit (G)before pasting.• Do not apply any glass cleaner after pasting the film antenna (F).