3 7KR-V9090/8090 (En/T)Remote ControlGetting the most from your remote controlThis operation lets you operate the registered components.KENWOOD audio components with system control turn on and off automatically with the receiver via the system controlconnections. !Operating other componentsAUDIOTVVIDEOAUDIOSHIFTMACROTVVIDEOGUIDERECMUTEVOLUMETUNING/SKIPTHEME FAVMENUFUNCTIONSHIFT SETUPINFO ALT AUDTV/SAT/VIDREPEAT RANDOM+100DISPLAYENT+10LISTENMODE SOUNDSUBWOOFER5 642 318 970874 ¢6BANDP. CALL P. CALLPOWERKeys or controls used in this operation.• Pressing the VIDEO or AUDIO key also changes the input selector onthe receiver. If you do not want to change the current input, press theSHIFT key before step 1. °• Pressing the SHIFT key is only required when turning the selectedcomponent on or off. Pressing the POWER key directy turns thereceiver on and off.• See "Remote operation of other components" at the end of this manualfor a list of keys available with each component. IThe remote control mode remains in the set at the compo-nent selected in step 1 mode until you select anothercomponent (etc.).Be sure to point the remote control at the remote sensor on the receiver when you want to operate KENWOOD components connected bysystem control cords. Otherwise, point the remote control at the component you want to operate.NoteNoteVIDEO key1 VIDEO1 (VCR 1)2 VIDEO2 (VCR 2)3 VIDEO3 (LD)4 AV AUXAUDIO key1 CD (CD)2 TAPE/MD(TAPE)3 TUNER4 PHONOTV key1 TV12 TV23 CABLE6BANDSHIFTER\\1 Use the VIDEO, AUDIO, or TV keys toselect the component you desire.2 Press the SHIFT key and then press thePOWER key (within 3 seconds).3 Press the operation keys you desire.