— 15 —Press the preset station button (#1-6) for the desired station.The number of the recalled station is displayed.• When the local seek function is turned while auto memoryentry takes place, stations with poor reception are not stored.• When the Traffic Information function is on , only the localtraffic information station frequency will be stored.NOTEContinue steps 3 and 4 until all the characters are chosen forthe name.You can enter up to 8 characters for each name.Assigning NamesPress the NAME.S button.The name of the station is stored in memory, and the StationName Preset mode ends.Also, if you make no input for 10 seconds, the name will bestored up to the point that you have entered, and the modeends.• You can assign names to up to 32 FM stations and 16 AMstations.• All the station names will be erased if you press the RESETbutton.• If you want to change the name of a station, first display thename of the station (following steps 1 and 2 above), thenchange the letter(s) that you want by following steps 3 and 4.NOTE6NOTE5Alphabet (upper case): A ~ ZAlphabet (lower case): a ~ zNumerals and symbols: 0~9 @ ” ‘ ` % & * + - = , . / \ < > [ ]Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ flâ ä ê ë î ï ô ö û ü ñ ç © Æ › fiYou can assign names to radio stations with the Station PresetMemory. Up to 32 FM stations and 16 AM stations can beassigned names.Adjust the frequency to the station whose name you want toenter.The station name preset function cannot be used when aprogram service name or radio text is displayed.Press the NAME.S button for at least two seconds."NAME SET" is displayed once the station name preset modeis entered.The cursor will blink in the position where letters are entered.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.Each time the 38 button is pressed, the characters to beentered change as listed below.Press the FM or AM button to display the desired character.Characters that can be displayed are as follows.432NOTE1Station Name Preset (SNPS)