— 41 —FRONT • LFRONT • RREAR • LREAR • RP.CONT.ANT.CONT.ILLUMIEXT. CONTConnecting Wires to TerminalsWhen only two speakers are being connected to the system, connect theconnectors either to both the front output terminals or to both the rear outputterminals (do not mix front and rear). For example, if you connect the +connector of the left speaker to a front output terminal, do not connect the -connector to a rear output terminal.2CAUTIONIf you connect the ignition wire (red) and the battery wire (yellow) to the carchassis (ground), you may cause a short circuit, that in turn may start a fire.Always connect those wires to the power source running through the fusebox.2WARNINGFM/AM antenna inputRear left output (White)Rear right output (Red)Fuse (10A)KENWOOD disc changer /DAB control inputWiring harness(Accessory1)White/BlackGray/BlackGreen/BlackPurple/BlackWhiteGrayGreenPurpleTo front leftspeakerTo front rightspeakerTo rear rightspeakerTo rear leftspeakerIgnition wire (Red)Battery wire (Yellow)Ground wire (Black) - (To car chassis)Ignition keyswitchCar fusebox(Main fuse)ACCCar fuse boxBatteryIf no connections are made, do not let the wire come out from the tab.Front left output (White) Front right output (Red)To connect the Disc changer orDAB unit, consult each manual.NOTEPower control wire (Blue/White)Motor antenna control wire (Blue)Dimmer control wire (Orange / White)When using the optional power amplifier, connectto its power control terminal.To car light control switchDepending on what antenna you are using, connecteither to the control terminal of the motor antenna, orto the power terminal for the booster amplifier of thefilm-type antenna.External amplifier control wire(Pink / Black)To "EXT.AMP.CONT." terminal of the amplifierhaving the external amp control function.Non-fading right output(Red)(KRC-X858 only)Non-fading left output(White) (KRC-X858 only)