Kenwood KRC-708 Instruction Manual

Also see for KRC-708: Service manual Service manual

— 9 —This function allows you to adjust the setting that is recalledwith the sound coordinate system, according to types ofspeakers.Press the SRC button repeatedly to select the standby mode."ALL OFF" is displayed when the standby mode is selected.Press the AUD button to enter the mobile preset plan mode.Press either the 4 or ¢ button to select the type ofspeaker. The setting switches as follows.OFF / For the OEM speaker / For 6/6x9 in. speaker /For 5/4 in. speakerPress the AUD button to end the mobile preset plan mode.• This mode is available only when the Sound coordinate systemis on. (page36)• When you change the setting of type of speaker, the bass andtreble tone settings are returned to original levels.NOTE4321Mobile PresetThis mode is available only when Sound coordinate system ison.( page36).Function of the KRC-X858Recalling your sound settings:Press a preset button (#1-6) except during the bass centerfrequency, bass level, bass quality factor, bass extension,treble center frequency, and treble level adjust mode.NOTEFunction of the KRC-X858Storing your sound settings:Press a preset button (#1-6) for at least two seconds.• This setting can be made only when the Sound coordinatesystem is on.( page36).• The settings you can preset are, bass center frequency, basslevel, bass quality factor, bass extension, treble centerfrequency, and treble level.NOTE"V OFFSET" : Set the sound level of the each source selected byadjusting the level difference between the basicsound level and the required level.Setting values: - 8 – 0Function of the KRC-X858"NF Phase" : Adjust the phase for Non-Fading output.Setting values: Normal (0°) / Reverse (180°)• This mode is available only when the non-fading output functionis set to on.( page10).• Not available during the Dual zone system is on.NOTEFunction of the KRC-708