Kenwood KRC-865 Instruction Manual

Also see for KRC-865: Service manual

English— 26 —1 Insert the removal tool into theindentations in the hard rubberframe, and pull it gently until thelock is released.Accessory8Removal tool3 Refer to the section "Removing the faceplate" (page 9) and thenreattaching the faceplate.Never insert the taptite screws (ø2 X 4 mm) in any other screw holesthan the one specified. If you insert it in another hole, it will contract andmay cause damage to the mechanical parts inside the unit.If you want to lock the faceplate to the unit so that it does not falloff, follow the directions below.1 Refer to the function "Removing the faceplate" (page 9) andremove the faceplate.2 Insert the provided screw into the hole at the center of thebottom side of the faceplate which you have removed from theunit.Accessory5Screw (M4X8)(commerciallyavailable)4 Push upward the removal tooltoward the top, and pull out theunit halfway while pressingtowards the inside.5 Pull the unit all the way out withyour hands, being careful not todrop it.Be careful to avoid injury from thecatch pins on the removal tool.2 Remove the screw (M4X8) onthe back panel.3 Insert the two removal toolsdeeply into the slots on eachside, as shown.Accessory2Removal toolLocking the faceplate to the unitRemoving the Unit