Kenwood KRF-V4060D Instruction Manual

Also see for KRF-V4060D: Instruction manual Service manual

Kenwood KRF-V4060D Instruction Manual Manual pdf 8 page image

8 ENSetting up the systemMake connections as shown in the following pages.When connecting the related system components, besure to refer to the instruction manuals supplied withthe components you are connecting.Do not connect the power cord to a wall outlet until allconnections are completed.Notes1. Be sure to insert all connection cords securely. If their connections areimperfect, the sound may not be produced or there will be noiseinterference.2. Be sure to remove the power cord from the AC outlet before pluggingor unplugging any connection cords. Plugging/unplugging connectioncords without disconnecting the power cord can cause malfunctionsand may damage the unit.3. Do not connect power cords from components whose powerconsumption is larger than what is indicated on the AC outlet at therear of this unit.Analog connectionsAudio connections are made using RCA pin cords. These cables transferstereo audio signal in an “analog” form. This means the audio signalcorresponds to the actual audio of two channels. These cables usuallyhave 2 plugs each end, one red for the right channel and one white forthe left channel. These cables are usually packed together with thesource unit, or are available at your local electronics retailer.Microcomputer malfunctionIf operation is not possible or an erroneous display appears, eventhough all connections have been made properly, reset themicrocomputer referring to “In case of difficulty”. ‹Input mode settingsCD/DVD, VIDEO2 and DVD or DVD/6CH (VR-615/KRF-V5060Donly) inputs each include jacks for digital audio input and analog audioinput.To use the analog audio input for playback instead (if, for example, youhave connected a VCR to the VIDEO2 input), you must set the inputmode for the corresponding input to the analog mode.After completing connections and turning on the receiver, follow thesteps below.1 Use the INPUT SELECTOR knob to select CD/DVD, VIDEO2,DVD or DVD/6CH (VR-615/KRF-V5060D only).2 Press the INPUT MODE key.Each press switches the setting as follows:In DTS play mode1 F-AUTO (digital input, analog input)2 D-MANUAL (digital input)In CD/DVD, VIDEO2, DVD or DVD/6CH (VR-615/KRF-V5060Donly) play mode1 F-AUTO (digital input, analog input)2 D-MANUAL (digital input)3 6CH INPT (DVD/6CH input)4 ANALOG (analog input)Digital input:Select this setting to play digital signals from a DVD, CD, or LDplayer.Analog input:Select this setting to play analog signals from a cassette deck, VCR,or record player.Auto detect:In “F-AUTO” (full auto) mode (AUTO DETECT and DIGITALindicators light up), the receiver detects the digital or analog inputsignals automatically. Priority is given to digital signal during inputmode selection. The receiver will select the input mode and listeningmode automatically during playback to match the type of inputsignal (Dolby Digital, PCM, DTS ) and the speaker setting. The initialfactory setting is full auto.To keep the receiver set to the currently selected listening mode,use the INPUT MODE key to select “D-MANUAL” (digital manual).However, even when this setting is selected, there may be casesin which the listening mode is selected automatically to match aDolby Digital source signal depending on the combination of listeningmode and source digital.If the INPUT MODE key is pressed quickly, sound may not beproduced. Press the INPUT MODE key again.INPUT MODEINPUT SELECTOR