Kenwood KRF-V4070D Instruction Manual

Also see for KRF-V4070D: Instruction manual Service manual Instruction manual

Kenwood KRF-V4070D Instruction Manual Manual pdf 18 page image

18 ENListening to a source component1Use the INPUT SELECTOR knob or keys to select the sourceyou want to listen to.The input sources change as shown below:1 “AUX”2 “TUNER”3 “CD/DVD”4 “TAPE” or “MD”5 “VIDEO1”6 “VIDEO2”7 “DVD” or “DVD/6CH” (for VR-715/KRF-V5070D only)2Start playback from the selected source.3Use the VOLUME CONTROL knob or VOLUME keys to adjustthe volume.Normal playbackSome preparatory steps are needed before starting playback.Turning on the receiver1 Turn on the power to the related components.2 Turn on the power to this receiver by pressing POWER ON/STANDBY (for VR-705/715) or POWER ON/OFF and ON/STANDBY (for KRF-V5070D/V4070D/V5570D) key.Selecting the input modeIf you have selected a component connected to the CD/DVD, VIDEO2,DVD or DVD/6CH (VR-715/KRF-V5070D only) jacks, make sure thatthe input mode setting is correct for the type of audio signal to be used.8Selecting MD/TAPESelect the source name corresponding to the component connected tothe MD/TAPE jacks. The initial factory setting is “TAPE”. To change thesource to “MD”, follow the steps below:1 Use the INPUT SELECTOR knob to select “TAPE”.2 Hold down the AUTO key for more than 2 seconds.• The source indication changes to “MD”.• To return to the original indication, repeat procedure 2.Setting the speaker statusPress the SPEAKERS ON/OFF key to switch the speaker on or off.Preparing for playbackThe speaker indicator lights up.AUTO INPUT SELECTOR(KRF-V5070D/V4070D/V5570D)POWERON/OFFSPEAKERSON/OFFON/STANDBY(KRF-V5070D/ V4070D/V5570D)(VR-705/715)POWERON/STANDBY INPUT SELECTORVOLUME CONTROLInputSelectorVOLUME